[Asterisk-Users] Zaptel modules load, but Asterisk fails at startup

[Stephen Bosch]

Francesco Peeters (Asterisk) wrote:
> On Wed, January 11, 2006 19:35, Stephen Bosch said:
> 
>>I'm running Asterisk on a Gentoo box with the Zaptel 1.2.1 drivers.
>>
>>If I boot the machine without having the wcfxs module autoload, then
>>install the module with modprobe, asterisk works just fine.
>>
>>If I boot the machine and autoload the wcfxs module, the module loads
>>fine:
>>
>>
>>>Jan 11 11:06:55 asterisk Zapata Telephony Interface Registered on major
>>>196
>>>Jan 11 11:06:55 asterisk ACPI: PCI Interrupt Link [LNKC] enabled at IRQ
>>>10
>>>Jan 11 11:06:55 asterisk PCI: setting IRQ 10 as level-triggered
>>>Jan 11 11:06:55 asterisk ACPI: PCI Interrupt 0000:00:0a.0[A] -> Link
>>>[LNKC] -> GSI 10 (level, low) -> IRQ 10
>>>Jan 11 11:06:55 asterisk Freshmaker version: 73
>>>Jan 11 11:06:55 asterisk Freshmaker passed register test
>>>Jan 11 11:06:55 asterisk Module 0: Installed -- AUTO FXS/DPO
>>>Jan 11 11:06:55 asterisk Module 1: Not installed
>>>Jan 11 11:06:55 asterisk Module 2: Not installed
>>>Jan 11 11:06:55 asterisk Module 3: Installed -- AUTO FXO (FCC mode)
>>>Jan 11 11:06:55 asterisk Found a Wildcard TDM: Wildcard TDM400P REV I (2
>>>modules)
>>
>>The module is running:
>>
>>
>>>asterisk sfbosch # lsmod
>>>Module                  Size  Used by
>>>wctdm                  39936  -
>>>zaptel                226756  -
>>>asterisk sfbosch #
>>
>>But Asterisk behaves as though it were not:
>>
>>
>>> [chan_zap.so] => (Zapata Telephony w/PRI)
>>>  == Parsing '/etc/asterisk/zapata.conf': Found
>>>Jan 11 11:32:53 WARNING[5778]: chan_zap.c:920 zt_open: Unable to specify
>>>channel 1: No such device or address
>>>Jan 11 11:32:53 ERROR[5778]: chan_zap.c:6847 mkintf: Unable to open
>>>channel 1: No such device or address
>>>here = 0, tmp->channel = 1, channel = 1
>>>Jan 11 11:32:53 ERROR[5778]: chan_zap.c:10251 setup_zap: Unable to
>>>register channel '1'
>>>Jan 11 11:32:53 WARNING[5778]: loader.c:414 __load_resource:
>>>chan_zap.so: load_module failed, returning -1
>>>Jan 11 11:32:53 WARNING[5778]: loader.c:554 load_modules: Loading module
>>>chan_zap.so failed!
>>>Warning, flexible rate not heavily tested!
>>>asterisk sfbosch # Ouch ... error while writing audio data: : Broken
>>>pipe
>>
>>Looking at this now as I write this, it seems that some module
>>dependencies aren't loading, but I can't be sure. Does anybody have an
>>idea what's going on here?
>>
>>-Stephen-
> 
> 
> Try running ztcfg -vvv

Yes, that fixes it -- my question, I guess, is how to get that to run
automatically at boot time...

-s