[asterisk-users] CISCO 2600 - VWIC 1MFT-E1

[Fran Oliveira]

As I understand your configuration , dial-peer voice 697617664 voip, only
forward the pattern 697617664( destination-pattern 697617664) to XXX.XXX.XXX
.115:5060  ( session target ipv4:XXX.XXX.XXX.115:5060) that I think is your
Asterisk box.
An incoming call in your E1 must much a destination pattern, your only
destination pattern is  697617664.
Usually an E1 has several DID associated it in a consecutive range, 91
5344XXX for example.

otherwise, for outgoing calls you must configure a pots dial peer ,you can
put a randon name to the dial peer.
You can configure asterisk , without user registration with the
sip.confinsecure option

 when I copied
dial-peer voice 10 pots
 destination-pattern 0T  should be .T
it tells cisco 26xx router what patterns can be reached throught E1
I´ll take a look into the cisco web site for sip user authentication, I have
a configuration done, but with FXS interfaces and worsk fine.

best regards





2006/12/7, FaberK <f.faberk at gmail.com>:
>
> http://pastebin.ca/270840
> This is the newone with some changements.
> Unfortunately, always the same problem.
>
> Fran, if I add the "dial-peer voice 10 pots", I receive the advise that
> the number does not exist.
> Also, I do not find the way to add "authentication username
> "asterisk-uername" password XXXXXX".
>
> The story continues...
>
> Thanks
>
> F.
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-users/attachments/20061208/fdad29b6/attachment.htm