[asterisk-users] Re: Wellgate 3804a

[Martin Joseph]

On 2006-08-24 08:43:01 -0700, Ronald Wiplinger <ronald at elmit.com> said:

> I want that each call from PSTN goes to Asterisk to the context for 
> this line. Within this context can be a menu or a dial command, ...
> As more I read, as more I get confused, ... and each try is not working!
> 
> 
> My sip.conf:
> 
> [WG88621001] type=friend defaultip=192.168.250.244
> insecure=very
> context=incoming_WG
> dtmfmode=rfc2833
> mailbox=88621001 at office
> language=en
> nat=yes
> auth=md5
> host=dynamic
> canreinvite=no
> disallow=all
> allow=ulaw
> allow=alaw
> allow=g726
> allow=g729
> username=88621001    fromuser=88621001   secret=xxxxxxxx             
> qualify=yes
> canreinvite=no
> 
> 
> extensions.conf
> [incoming_WG]
> exten => s,1,NoOp(*** I am here now ***)
> 
> 
> 
> Wellgate settings:
> 
> Network Interface: IP address of the device 192.168.250.244
> 
> Sip Config: Mode Proxy
>     Primary Proxy IP address:  192.168.250.20
>     Line 1 Number:    88621001
>    Security Config
>     Line1 Account:  WG8862001
>     Line 1 password:   (secret from the asterisk setting)
> 
> Line configuration
>     Line 1 (LINE)   Type: FXO   Hunting Group: 1   HotLine: 601   
> Registration: Not Registered   Status: Ready
> 
> System Configuration
>     Keypad type:   rfc2833
> 
> Routing Table
>     Index: IP Default     Destination: FXO              E.164: x
>     Index: FXO             Destination: IP Default      E.164: x
> 
> 
> 
> *CLI> sip show peers like ^WG
> Name/username              Host            Dyn Nat ACL Port     Status  
>  WG88621001/88621001        (Unspecified)    D   N      0        
> UNKNOWN  1 sip peers [0 online , 1 offline]
> 
> 
> 
> Calls from PSTN comes to the IVR asking for the extension number and 
> than nothing happens. Asterisk shows nothing either.
> 
> Can somebody enlighten me:
> 1. Do I need to have a register statement in sip.conf?
> (I tried register => 88621001:secret-from-above   ; Wellgate GW.3801-Line-1)
No.
> 
> 2. where to turn off the IVR?
I think when you set the Routing table it goes away.  My routing table 
is set to IP default to FXO and both FXO and FXS default to IP
> 
> 3. Do I use the right  name, user name, line account, line ????
Dunno
> 
> 4. Hotline. Why, how, which number??
I am using the hotline to ring my asterisk extension when a call come 
to the FXO line.

Hope this helps
Marty