[asterisk-users] Integrating Asterisk with a Panasonic D500 using MFC/R2

[leonimar cape]

Hi Steve,

I notice that everytime I command a reload on the
asterisk my unicall channels gets also reset. So all
going calls got cut-off. Any suggestion that I should
do avoid this problem?

Regards,

Leonimar

--- Steve Underwood <steveu at coppice.org> wrote:

> Thierry Querette wrote:
> 
> >
> > Hi Carlos,
> >
> > I had the same problem and spent a lot of time
> studying the MFC/R2 
> > protocol .... but the problem is in the libmfcr2
> package version!!
> >
> > Try using the packages in: 
> >
> >
>
http://www.soft-switch.org/downloads/unicall/unicall-0.0.3pre7
> >
> > And not in pre9.
> >
> > Both "pre7" and "pre9" have libmfcr2-0.0.3.tar.gz 
> >
>
<http://www.soft-switch.org/downloads/unicall/unicall-0.0.3pre7/libmfcr2-0.0.3.tar.gz>
>  
> > with the same name..  but in different sizes. They
> are different.
> 
> pre9 works just fine. His problem is something
> completely different. His 
> configuration does not match the requirements of the
> PBX.
> 
> Steve
> 
> _______________________________________________
> --Bandwidth and Colocation provided by Easynews.com
> --
> 
> asterisk-users mailing list
> To UNSUBSCRIBE or update options visit:
>   
>
http://lists.digium.com/mailman/listinfo/asterisk-users
> 


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com