[Asterisk-Users] TE205P in loopback?
Steve Totaro
asterisk at totarotechnologies.com
Wed Sep 28 22:28:02 MST 2005
It flashes red until the properly made cables are connected and then should turn to solid green. Again, I suspect your cable is the issue. Are all the drivers loaded? ztcfg? Asterisk running? One span set to pri_cpe and the other to pri_net?
----- Original Message -----
From: Franciraldo Cavalcante Junior
To: asterisk-users at lists.digium.com
Sent: Wednesday, September 28, 2005 6:47 PM
Subject: Re: [Asterisk-Users] TE205P in loopback?
The board flashes red without cables and continues flashing red after cables are connected. Should it flash green before? I don't see anything weird in dmegs results.
----------------------------------------------------------------------------
From: "Steve Totaro" <asterisk at totarotechnologies.com>
Reply-To: Asterisk Users Mailing List - Non-Commercial Discussion<asterisk-users at lists.digium.com>
To: "Asterisk Users Mailing List - Non-Commercial Discussion"<asterisk-users at lists.digium.com>
Subject: Re: [Asterisk-Users] TE205P in loopback?
Date: Wed, 28 Sep 2005 21:12:08 -0700
If the cables are connected and the lights are still flashing red then I suspect that the cable is the issue.
----- Original Message -----
From: Franciraldo Cavalcante Junior
To: asterisk-users at lists.digium.com
Sent: Wednesday, September 28, 2005 5:44 PM
Subject: Re: [Asterisk-Users] TE205P in loopback?
I did the cable and configuration as recomended, but I may have another problem. After I run:
modprobe zaptel
modprobe wct2xxp
I don't see the boards flashing green it's flashing red and in sync, as I implicitly understand from your message . Should it flash green and when correctly cabled and configured, keep green?
How can I debug this?
any help is appreciated.
-f
------------------------------------------------------------------------
From: "Steve Totaro" <asterisk at totarotechnologies.com>
Reply-To: Asterisk Users Mailing List - Non-Commercial Discussion<asterisk-users at lists.digium.com>
To: "Asterisk Users Mailing List - Non-Commercial Discussion"<asterisk-users at lists.digium.com>
Subject: Re: [Asterisk-Users] TE205P in loopback?
Date: Wed, 28 Sep 2005 20:12:40 -0700
I just did this on a te410p.
make a t1 crossover, cross pins one with four, and two with five. Set one span for pri_cpe and the other side for pri_net. boom, you are done and can start testing. the lights should turn solid green and you should first see the D channels come up and then all the B channels, if this happens, you have done it correctly.
thanks,
Steve
----- Original Message -----
From: Franciraldo Cavalcante Junior
To: asterisk-users at lists.digium.com
Sent: Wednesday, September 28, 2005 4:46 PM
Subject: [Asterisk-Users] TE205P in loopback?
I'm a new * user and had just intalled A TE205P line in my Linux machine (running linux kernel 2.6.10). I would like to test the T1 interface but I don't have an ISDN PRI interface available right now. Is there a way to make some sort of loopback test? How to configure it? Do I need the cables to have tx/rx exchanged?
Any help would be appreciated.
- f
----------------------------------------------------------------------
_______________________________________________
--Bandwidth and Colocation sponsored by Easynews.com --
Asterisk-Users mailing list
Asterisk-Users at lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
----------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.344 / Virus Database: 267.11.8/113 - Release Date: 9/27/05
>_______________________________________________
>--Bandwidth and Colocation sponsored by Easynews.com --
>
>Asterisk-Users mailing list
>Asterisk-Users at lists.digium.com
>http://lists.digium.com/mailman/listinfo/asterisk-users
>To UNSUBSCRIBE or update options visit:
> http://lists.digium.com/mailman/listinfo/asterisk-users
--------------------------------------------------------------------------
_______________________________________________
--Bandwidth and Colocation sponsored by Easynews.com --
Asterisk-Users mailing list
Asterisk-Users at lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
--------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.344 / Virus Database: 267.11.8/113 - Release Date: 9/27/05
>_______________________________________________
>--Bandwidth and Colocation sponsored by Easynews.com --
>
>Asterisk-Users mailing list
>Asterisk-Users at lists.digium.com
>http://lists.digium.com/mailman/listinfo/asterisk-users
>To UNSUBSCRIBE or update options visit:
> http://lists.digium.com/mailman/listinfo/asterisk-users
------------------------------------------------------------------------------
_______________________________________________
--Bandwidth and Colocation sponsored by Easynews.com --
Asterisk-Users mailing list
Asterisk-Users at lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.344 / Virus Database: 267.11.8/113 - Release Date: 9/27/05
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-users/attachments/20050928/3ef9f23b/attachment.htm
More information about the asterisk-users
mailing list