[Asterisk-Users] asterisk@home isdn

[Tomasz Chmielewski]

Alejandro Vargas schrieb:
> I'm testing asteriskathome with an ISDN card
> 
> 00:0a.0 Network controller: Cologne Chip Designs GmbH ISDN network
> controller [HFC-PCI] (rev 02)
> 
> I found there is the module hisax and I loaded it:
> 
> hisax                 456177  0
> crc_ccitt               2113  2 hisax,zaptel
> isdn                  133409  1 hisax
> 
> dmesg shows this:
> HiSax: Linux Driver for passive ISDN cards
> HiSax: Version 3.5 (module)
> HiSax: Layer1 Revision 2.46.2.5
> HiSax: Layer2 Revision 2.30.2.4
> HiSax: TeiMgr Revision 2.20.2.3
> HiSax: Layer3 Revision 2.22.2.3
> HiSax: LinkLayer Revision 2.59.2.4
> 
> I'm not sure if it is detecting the hardware, and I'm not sure what
> config I must do in asterisk. The documentation is confusing, because
> the references to hisax indicates to use cahan_modem_i4l but comments
> in modules.conf says "DON'T load the chan_modem.so, as they are
> obsolete in * 1.2". I tryed anyway but chan_mdem_i4l does not appear
> whan I type reload.

you have to use bristuff-0.3.x (from www.junghanns.net) with a HFC card, 
not HiSax (well, technically, you could use HiSax too, but avoid that if 
possible).


-- 
Tomek
http://wpkg.org
WPKG - software deployment and upgrades with Samba