[Asterisk-Users] Reboot stops TD400P cards from outgoing calls until first incoming call arrives

[Rich Adamson]

------------------------
  From: "James B. MacLean" <macleajb at ednet.ns.ca>

---------------End of Original Message-----------------

I hope the files that you attached have different names then what
was shown since there is nothing used by * called zap.conf or zapa.conf.

The parameters in zaptel.conf look correct "if" they match up with
the appropriate modules (red & green) installed on the TDM boards.

The parameters in zapata.conf appear to be a little wild. As the
parameters are read, they are inherited by each section below it
unless otherwise changed. So, usecallingpres=yes (as an example only)
is inherited by each channel (regardless of whether you know it as a
fxo or fxs port). Restructuring the contents might be a good place
to start.

I'd suggest removing the majority of the statements and starting out
with very basic definitions, then when things are working reasonably
well, add in other statements (like callerid, etc).

You might also take a look at 'zap show status' and 'zap show channels'
to ensure definitions are reasonable.

Might also try 'set debug 99' and/or 'set verbose 99' and watch an
outgoing call to see if additional info is provided on the CLI.