[Asterisk-Users] TDM400 FXO port 1 only problem.

[Gary Eck]

I had the same problem - I swapped modules, and the problem stayed with
channel 1. I got a replacement from my distributor, but it had the same
problem.

I ended up getting a board directly from Digium - that solved the
problem.

-----Original Message-----
From: asterisk-users-bounces at lists.digium.com
[mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of Tom Vile
Sent: Tuesday, November 22, 2005 6:31 PM
To: Rich Adamson
Cc: Asterisk Users Mailing List - Non-Commercial Discussion
Subject: Re: [Asterisk-Users] TDM400 FXO port 1 only problem.


The problem is not the module though its on the port its plugged into.
I can move the module to another port and it works fine, so I was
thinking it is the board.  I guess I will call Digium and see what they
say.

thanks

On 11/22/05, Rich Adamson <radamson at routers.com> wrote:
>
> > I have a TDM400 REV I Ver 1 board and am having an issue with 1 of 
> > the 4 FXO channels.  FXO 1 always has clicks, pops and echo but the 
> > others are crystal clear all of the time.  The card is on its own 
> > IRQ zztest shows 100% to 99.98%  and is getting 1000 int per second.

> > Its not dropping interrupts either.
> >
> > I ran FXOTUNE and it did nothing to fix the issue
> >
> > It only is happening on FXO port 1
> >
> > Anything else to try?
>
> Sure... call digium support. They'll probably rma the module.
>
>
>


--
Tom Vile
Baldwin Technology Solutions, Inc
Consulting - Web Design - VoIP Telephony www.baldwintechsolutions.com
Phone: 518-631-2855 x205
Phone: 978-203-3848 x205
Fax:     518-631-2856
_______________________________________________
--Bandwidth and Colocation sponsored by Easynews.com --

Asterisk-Users mailing list
Asterisk-Users at lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users