[Asterisk-Users] Error in Zapata Config?

[Rich Adamson]

If you mentioned it, I missed it. I'm assuming you are trying to
use a digium TDM-fxo card?

> When I reload the config, I see this error in the CLI. However, I don't see
> what I have done wrong:
> 
>   == Parsing '/etc/asterisk/zapata.conf': Found
> May 30 16:38:42 WARNING[12630]: chan_zap.c:10088 setup_zap: Ignoring
> signalling
>     -- Reconfigured channel 1, FXO Kewlstart signalling
> May 30 16:38:42 WARNING[12630]: chan_zap.c:10088 setup_zap: Ignoring
> signalling
>     -- Reconfigured channel 2, FXO Kewlstart signalling
> May 30 16:38:42 WARNING[12630]: chan_zap.c:10088 setup_zap: Ignoring
> signalling
>     -- Reconfigured channel 3, FXS Kewlstart signalling
>     -- Reconfigured channel 4, FXS Kewlstart signalling
> 
> Here is my config
> /etc/asterisk/zapata.conf
> 
> [channels]
> context=internal
> signalling=fxo_ks

If it is a TDM card with fxo modules, then the above should be fxs_ks,
and the same for the ones below.

> rxgain=0
> txgain=20
> channel => 1
> 
> context=analog2
> signalling=fxo_ks
> rxgain=0
> txgain=0
> channel => 2
> 
> context=pstn
> signalling=fxs_ks
> faxdetect=incoming
> echotraining=800
> echocancel=128
> echocancelwhenbridged=yes
> relaxdtmf=yes
> rxgain=10
> txgain=0
> immediate=no
> busydetect=no
> callprogress=no
> musiconhold=default
> usecallerid=yes
> useincomingcalleridonzaptransfer=yes
> callerid=asreceived
> group=1
> ;channel => 4
> channel => 3,4
> 
> Thanks for any help,

If you're not using a TDM card, then tell us what it is that
you're trying to configure. Might also include /etc/zaptel.conf
in the next post.