[Asterisk-Users] PRI setup

[Jay Milk]

You don't know how to compile asterisk?  So why'd you ask about PRI?  If
you're starting from scratch, google for "Getting Started with Asterisk"
and click on the first link.

You might be better off hiring an asterisk consultant to get you through
this.

> -----Original Message-----
> From: Mike M [mailto:no-linux-support at earthlink.net] 
> Sent: Thursday, May 26, 2005 6:41 AM
> To: asterisk-users at lists.digium.com
> Subject: Re: [Asterisk-Users] PRI setup
> 
> 
> On Thu, May 26, 2005 at 01:30:03AM -0500, Jay Milk wrote:
> 
> > http://www.digium.com/downloads/configuring_zaptel.pdf
> 
> Nothing new here. This is more or less a verbatim copy of what's 
> in /etc/zaptel.conf which is (2) below.
> 
> > http://www.voip-info.org/wiki-Asterisk+config+zaptel.conf
> > http://www.voip-info.org/wiki-Asterisk+config+zapata.conf
> 
> Nothing new here either. The PRI information in these two links 
> is covered in the (1) below.  The example is exactly the same.
> > 
> > Google is your friend.
> 
> You might think that "asterisk+pri" or 
> "asterisk+pri+configuration" or "asterisk+pri.configuration" 
> would turn up more than emails from 2002.  I even found the 
> email where libpri was released under GPL:
> 
> http://www.marko.net/asterisk/archives/0105/0022.html
> 
> What I haven't found is a guide that gives the following steps:
> ------------------------------------------------------------------
> 1) compile/install libpri
> 2) compile/install asterisk
> 3) here's how to tell if your asterisk load is PRI ready
> 4) gather this information from your service provider
> 5) configure the collected information like this (OK, this 
> does exist if
>    you know what to google for)
> 6) here's how to test and troubleshoot your PRI connection
> 
> If such a document doesn't exist then I'll start one because 
> I'm getting ready to go through the process.  If it does 
> exist, then I'd like to follow it.
> 
> -- 
> Mike
> > 
> > > -----Original Message-----
> > > From: Mike M [mailto:no-linux-support at earthlink.net]
> > > Sent: Wednesday, May 25, 2005 9:44 PM
> > > To: Asterisk Users Mailing List - Non-Commercial Discussion
> > > Subject: Re: [Asterisk-Users] PRI setup
> > > 
> > > 
> > > On Wed, May 25, 2005 at 09:41:13PM -0400, Mike M wrote:
> > > > I can't find documentation for setting up PRI.
> > > > 
> > > > A push in the right direction would be most appreciated.
> > > 
> > > Sorry for replying to my own post.
> > > 
> > > I found:
> > > 
> > > 1) http://www.digium.com/downloads/hw_article
> > > 2) the comments in /etc/zaptel.conf
> > > 3) a good discussion on timing choice: 
> > > http://lists.digium.com/pipermail/asterisk->
> > users/2005-May/107292.html
> > > 
> > > Is there more?
> > > 
> > > Thanks again,
> > > --
> > > Mike
> > > _______________________________________________
> > > Asterisk-Users mailing list
> > > Asterisk-Users at lists.digium.com
> > > http://lists.digium.com/mailman/listinfo/aster> isk-users
> > > To 
> > > UNSUBSCRIBE or update options visit:
> > >    
> > http://lists.digium.com/mailman/listinfo/asterisk-users
> > 
> > 
> > 
> > _______________________________________________
> > Asterisk-Users mailing list
> > Asterisk-Users at lists.digium.com 
> > http://lists.digium.com/mailman/listinfo/asterisk-users
> > To UNSUBSCRIBE or update options visit:
> >    http://lists.digium.com/mailman/listinfo/asterisk-users
> > 
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com 
> http://lists.digium.com/mailman/listinfo/aster> isk-users
> To 
> UNSUBSCRIBE or update options visit:
>    
http://lists.digium.com/mailman/listinfo/asterisk-users