[Asterisk-Users] Re: cisco 3620 setup (newbie cisco alert)

[info at beprojects.com]

You need an NM-HDV card of some sort to run voice.  The WIC-1MFT-E1 can 
handle voice, but you still need the DSP's to use it as a voice card. 
Putting that into an NM-HDV that has DSP's will make the voice ports and 
dsp's show up.


Asterisk wrote:
> ok, I'm starting to get confused, you must be getting annoyed .. how do 
> I add this voice-port ?
> 
> Also, if I want to use * to handle all of the SIP internal calls, and 
> cisco to handle to inbound and outbound isdn-32 PRI calls, what "feature 
> set" of the IOS should I need ? What hardware on the cisco 3620 should I 
> need ? I've got a PRI-1CE1U and a WIC-1MFT-E1 and a two-port fast 
> ethernet. I also have a 2610 to play with if required :)
> 
> Many thanks for your help. It is much appreciated. There is only so much 
> a newbie can do without advice.
> 
> Julian.
> 
> barney wrote:
> 
>> I can`t see voice-port in your configuration. Something like this:
>>
>> !
>> voice-port 1/0:15            ; voice-port 1/0:15, if your D channel is 
>> Serial1/0:15
>> input gain -6
>> output attenuation 14
>> echo-cancel coverage 32
>> echo-cancel suppressor
>> cptone SK
>> description E1
>> bearer-cap Speech
>> !
>>
>> If you configure voice-port, try again to configure dial-peer (port 
>> x/y:15 command) and if you have DSPs in you box, you must see 
>> something like this:
>>
>> SIP-3640#show voice dsp
>>
>> DSP  DSP             DSPWARE CURR  BOOT                         PAK TX/RX
>> TYPE NUM CH CODEC    VERSION STATE STATE   RST AI VOICEPORT TS ABORT  
>> PACK COUNT
>> ==== === == ======== ======= ===== ======= === == ========= == ===== 
>> ============
>> C549 000 00 {high}    3.4.56 IDLE  idle      0  0 2/0:15    01     0 0/16
>>         01 {high}    3.4.56 IDLE  idle         0 2/0:15    17     0 0/0
>> C549 001 00 {high}    3.4.56 IDLE  idle      0  0 2/0:15    02     0 0/16
>>         01 {high}    3.4.56 IDLE  idle         0 2/0:15    18     0 0/0
>> ....
>>
>> If you don`t have any DSP in your C3620, it will be unusable. So check 
>> it!
>>
>> -b
>>
> 
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
> To UNSUBSCRIBE or update options visit:
>   http://lists.digium.com/mailman/listinfo/asterisk-users
> 
> .
>