[Asterisk-Users] Outgoing calls, X100P

[Mehmet Tolga Avcioglu]

I tried that and it didn't work. Then I decided to use a different phone 
line. I had not thought about this before, it just didn't occur to me. 
And everything worked fine. The phone line that doesn't work is my ADSL 
line. Wall to splitter, one side going to ADSL router the other going 
into a fax machine and than from fax machine going into X100P. I 
remember seeing a post about this before. I'll have to check into that. 
Any other regular phone is able to pick up and dial through this line 
with no problem.

Thanks for the help

--
Mehmet

Iain Young wrote:
> On Mon, May 02, 2005 at 01:02:34PM -0400, Mehmet Tolga Avcioglu wrote:
>  
> 
>>I can't seem to be able to make outgoing calls with X100P card. I can 
>>receive calls fine and it picks up the line and sends the tones, but the 
>>telco doesn't recognize them. While the tones are sent I continue to 
>>hear the dial tone on the line when I pick up a parallel. I also cannot 
>>dial from the parallel until X100P hangs up the line.
> 
> 
> I had the same trouble, here in the UK. What do you have rxgain and
> txgain set at in zapata.conf ? 
> 
> I found I had to raise the txgain to 0.25 to get it to work on my
> British Telecom line (Cable Provider's line was fine)
> 
> I also had to up even further (to 3.0) in order to get inbound fax to
> work, although I think I can back that off a little.
> 
> Of course, increasing the gain also gives me an echo issue, in 
> proportion to the gain values, so I suspect I have an impedance
> issue. YMMV of course.
> 
> 
> Hope that Helps
> 
> Iain
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-users