[Asterisk-Users] MFC/R2 in the Philippines

[Steve Underwood]

Dido Sevilla wrote:

>I've been struggling with getting the soft-switch.org Unicall/MFC-R2
>implementation working. After wading through some misleading
>instructions and a build process that leaves much to be desired in
>terms of reliability and consistency (e.g., the order in which the
>various libraries should be compiled is plain wrong: I believe it
>should be spandsp, supertone, unicall, and mfcr2 in that order) , I've
>finally managed to get a working chan_unicall.so module used by
>Asterisk.  From searching through the mailing list archives, I see
>that I seem to have gone a good deal of the way, up to the point where
>I see the "warnings" about channels being unblocked on the near and
>far ends when * starts. However, when I attempt to initiate an
>outbound call with Asterisk, it suddenly fails with what I gather is a
>congestion error. "no one is available to answer at this time".
>
>I am quite certain it is not a problem with the E1R2 we are using, as
>it had previously been in use on a Nortel PBX and was working fine
>there. I'm trying to use the Philippine R2 variant.
>
>Does anyone have a sample configuration that works for the
>Philippines? Any help on this is much appreciated.
>  
>
You attitude in this message has just ensured you that if you have any 
problems you are entirely on your own.

Bye bye

Steve