[Asterisk-Users] Problems editing oh323 configuration parameters

[Alex Vishnev]

You don't have any codecs configured in your oh323 conf. also FastStart with
H245 tunneling should be enabled to get the best call-setup out of h323. 
 
  _____  

From: asterisk-users-bounces at lists.digium.com
[mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of Cenk Yabas
Sent: Thursday, March 31, 2005 7:18 AM
To: asterisk-users at lists.digium.com
Subject: [Asterisk-Users] Problems editing oh323 configuration parameters
 
Checking the oh323 configuration on asterisk console gives the following
result below. I'm editing the /etc/asterisk/oh323.conf file to correct the
parameters, but the result doesn't change. I didn't receive any error
massages during the installation of asterisk-oh323-0.7.1 channel driver. So
what might be wrong?
 
localhost*CLI> oh323 show conf
localhost*CLI>
 Configuration of OpenH323 channel driver
------------------------------------------
Version: 0.7.1
Listening on address: :1720
Gatekeeper used:  Failed
FastStart/H245Tunnelling/H245inSetup: OFF/OFF/OFF
Supported formats in pref. order:
Jitter buffer limits (min/max): 20-100 ms
TCP port range: 5000 - 31000
UDP (RAS) port range: 5000 - 31000
UDP (RTP) port range: 10000 - 20000
IP Type-of-Service value: 0
User input mode: 2
Max number of inbound H.323 calls: 0
Max number of outbound H.323 calls: 0
Max number of simultaneous H.323 calls: -1
Max call rate (ingress direction): 999999.00/30
 
Thanks in advance for any help,
Cenk Yabas.
 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-users/attachments/20050331/c05d35f2/attachment.htm