[Asterisk-Users] Unknown signalling 896?

[Eric Wieling]

David Zanetti wrote:
> I've been beating my head a bit against the 1.0.6 Debian builds of
> Asterisk, using an E100P (E1, single span) board.
> 
> In machines I've built in the past (back in 1.0.0 days), config I'm
> using and that card and 1.0.0 driver combo worked fine.
> 
> ztcfg reports no problems:
> 
> 	SPAN 1: CCS/HDB3 Build-out: 0 db (CSU)/0-133 feet (DSX-1)
> 	31 channels configured.
> 
> And zttool sees the card, and reports it in the state I expect (there's
> no real E1 attached to it, so blue/red alarms..)
> 
> But * won't bring up chan_zap at all:
> 
> 	ERROR[2215]: Signalling requested is PRI Signalling but line is
> 	in Unknown signalling 896 signalling
> 	ERROR[2215]: Unable to register channel '1-30'
> 	WARNING[2215]: chan_zap.so: load_module failed, returning -1
> 	WARNING[2215]: Loading module chan_zap.so failed!
> 
> Ideas? I'm sure it's something simple I've missed. :)
> 
> Config fragments follow:
> 
> ==/etc/zaptel.conf==
> span=1,0,0,ccs,hdb3
> bchan=1-15,17-31
> dchan=16
> loadzone=nz
> defaultzone=nz
> ==end==
> 
> ==/etc/asterisk/zapata.conf==
> context = default
> switchtype = euroisdn
> priindication = outofband
> group = 2
> signalling = pri_cpe
> channel => 1-30
> ==end==

Notice the [channels] lines at the top of the zaptel.conf.sample?  You 
need it.

--Eric

-- 
Always do right. This will gratify some people and astonish the rest.
Mark Twain