[Asterisk-Users] How can you check that egTDM04Bhardwareinstalled and drivers OK

Steve Totaro asterisk at totarotechnologies.com
Mon Jun 27 18:26:49 MST 2005


I pulled down the latest zaptel and still no joy.  Anyone else having any
issues with a revision I boards?  This is in a Dell SC420 which I know is
not recommended.


> If I recall correctly, there was a cvs change recently to support the
> new card. My current cvs-head wctdm.c is dated June 22. You probably
> need to pull a fresh copy of the zaptel directory.
>
> ------------------------
>
> > I just purchased two rev I boards and they cannot be recognized at all
but a
> > revision H (that reports E/F) board works ok.
> >
> >
> > ----- Original Message ----- 
> > From: "John Novack" <jnovack at stromberg-carlson.org>
> > To: "Asterisk Users Mailing List - Non-Commercial Discussion"
> > <asterisk-users at lists.digium.com>
> > Sent: Wednesday, June 22, 2005 6:08 AM
> > Subject: Re: [Asterisk-Users] How can you check that egTDM04B
> > hardwareinstalled and drivers OK
> >
> >
> > > Probably means that your perfectly good motherboard can't see the TDM
> > card.
> > > There are many motherboards that this card doesn't seem to work with,
> > > Digium doesn't seem willing to address the issue or even acknowledge
> > > that is the case, and usually answers " try another motherboard"
rather
> > > than 'fess up that there is a design problem with the PCI interface
and
> > > correct it.
> > > PCI 2.2 is a stated requirement, but there is certainly more to the
> > > story than that.
> > >
> > > In addition, when the board CAN be seen, report rev E/F when  the
> > > silkscreen reads Rev H, someone mentioned there is now a Rev I ( good
> > > luck getting an exchange ) and Digium 's answer is " if we can see it
> > > through remote access" then there is no reason to replace it, and if
we
> > > can't, try another MB.
> > >
> > > Overall, if it works, lucky you, if not, Too bad.
> > > Hard to support Digium and suggest others purchase such a product.
> > > Best you look for other interfaces to Asterisk.
> > >
> > > John Novack
> > >
> > >
> > >
> > >
> > > Angus Comber wrote:
> > >
> > > > If I try dmesg - no mention of a Wildcard TDM400.
> > > >
> > > > Sorry I am fairly new to Linux.  In Windows I suppose I would run
some
> > > > hardware program which came with the card to see if I could manually
> > > > set IRQ's etc.  What should I be looking at now?
> > > >
> > > > Please feel free to point me to a good book or whatever you feel is
> > > > appropriate.  Could the card be faulty?
> > > >
> > > > My motherboard is an Intel D865GLC.
> > > >
> > > > I am running Asteiks at Home version 1.0
> > > >
> > > > Angus
> > > >
> > > >
> > > >
> > > >
> > > > ----- Original Message ----- From: "Mike M"
> > > > <no-linux-support at earthlink.net>
> > > > To: <asterisk-users at lists.digium.com>
> > > > Sent: Tuesday, June 21, 2005 3:14 PM
> > > > Subject: Re: [Asterisk-Users] How can you check that eg TDM04B
> > > > hardwareinstalled and drivers OK
> > > >
> > > >
> > > >> On Tue, Jun 21, 2005 at 07:09:46AM -0600, Rich Adamson wrote:
> > > >>
> > > >>>
> > > >>> > I am struggling to get my TDM04B working.  Just to rule out a
> > > >>> hardware > problem how can I check
> > > >>> that the hardware works?  How can I then
> > > >>> > check that the drivers are loaded correctly?
> > > >>> >
> > > >>>
> > > >>> 1. from the linux command line, type 'dmesg' and look for
> > > >>>  Found a Wildcard TDM: Wildcard TDM400P REV H (4 modules)
> > > >>> if you see that, the TDM card is recognized by the OS.
> > > >>>
> > > >>
> > > >> Here's what I get on a working system:
> > > >>
> > > >> [root at b2 src]# modprobe wctdm
> > > >> [root at b2 src]# Jun 21 10:10:55 b2 kernel: PCI: Found IRQ 11 for
device
> > > >> 01:0a.0
> > > >> Jun 21 10:10:55 b2 kernel: Freshmaker version: 71
> > > >> Jun 21 10:10:55 b2 kernel: Freshmaker passed register test
> > > >> Jun 21 10:10:55 b2 kernel: Module 0: Installed -- AUTO FXS/DPO
> > > >> Jun 21 10:10:55 b2 kernel: Module 1: Not installed
> > > >> Jun 21 10:10:55 b2 kernel: Module 2: Not installed
> > > >> Jun 21 10:10:55 b2 kernel: Module 3: Not installed
> > > >> Jun 21 10:10:55 b2 kernel: Found a Wildcard TDM: Wildcard TDM400P
REV
> > > >> E/F (4 modules)
> > > >> Jun 21 10:10:55 b2 kernel: Registered tone zone 0 (United States /
> > North
> > > >> America)
> > > >>
> > > >> [root at b2 src]# cat /proc/interrupts
> > > >>           CPU0
> > > >>  0:   17893766          XT-PIC  timer
> > > >>  1:          2          XT-PIC  keyboard
> > > >>  2:          0          XT-PIC  cascade
> > > >>  4:  357411641          XT-PIC  eth0, wanpipe1
> > > >>  8:          1          XT-PIC  rtc
> > > >> 10:    3381408          XT-PIC  Intel ICH2
> > > >> 11:  178236906          XT-PIC  wctdm
> > > >> 14:      50492          XT-PIC  ide0
> > > >> 15:          0          XT-PIC  ide1
> > > >> NMI:          0
> > > >> ERR:          0
> > > >> [root at b2 src]# cat /proc/interrupts
> > > >>           CPU0
> > > >>  0:   17894203          XT-PIC  timer
> > > >>  1:          2          XT-PIC  keyboard
> > > >>  2:          0          XT-PIC  cascade
> > > >>  4:  357419974          XT-PIC  eth0, wanpipe1
> > > >>  8:          1          XT-PIC  rtc
> > > >> 10:    3381408          XT-PIC  Intel ICH2
> > > >> 11:  178241275          XT-PIC  wctdm
> > > >> 14:      50494          XT-PIC  ide0
> > > >> 15:          0          XT-PIC  ide1
> > > >> NMI:          0
> > > >> ERR:          0
> > > >>
> > > >> -- 
> > > >> Mike
> > > >
> > >
> > > _______________________________________________
> > > Asterisk-Users mailing list
> > > Asterisk-Users at lists.digium.com
> > > http://lists.digium.com/mailman/listinfo/asterisk-users
> > > To UNSUBSCRIBE or update options visit:
> > >    http://lists.digium.com/mailman/listinfo/asterisk-users
> > >
> >
> > _______________________________________________
> > Asterisk-Users mailing list
> > Asterisk-Users at lists.digium.com
> > http://lists.digium.com/mailman/listinfo/asterisk-users
> > To UNSUBSCRIBE or update options visit:
> >    http://lists.digium.com/mailman/listinfo/asterisk-users
> >
>
> ---------------End of Original Message-----------------
>
>
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-users
>




More information about the asterisk-users mailing list