[Asterisk-Users] X100P installed OK, after added TDM400P Asterisk would no longer start

[Ralf Schlatterbeck]

On Sat, Jun 04, 2005 at 11:20:47PM +0100, Angus Comber wrote:
> This is what I have:
> 
> # Span 1: WCTDM/0 "Wildcard TDM400P REV H Board 1"
> fxoks=1
> fxoks=2
> fxoks=3
> # channel 4, WCTDM, inactive.
> 
> # Span 2: WCFXO/0 "Wildcard X101P Board 1"
> fxsks=5
> 
> # Global data
> 
> loadzone = us
> defaultzone = us
> 
> 
> Which from your response appears correct.
> 
> Could it have confused the cards?  If I swap them in the config might that 
> work?
Depends on the order you load the drivers I think. So swapping them in
the config will probably help, yes. The FXS modules would then be 5-7
and the FXO 1...

You really have two boards, one with 3 FXS modules and one with a single
FXO module?

Ralf
-- 
Ralf Schlatterbeck
email: ralf at zoo.priv.at FAX: +43/2243/26465/23