[Asterisk-Users] Re: why zap call transfer fails?

[Michael Jia]

Some further observation. Using the following config, I can dial 8 , reach the 
outbound line and get a dial tone without any problem. Then I can dial
any number from that point on.

exten => 8,1,Answer
exten => 8,2,Dial(Zap/4/)
exten => 8,3,Hangup

It looks more to me a timing issue, is Asterisk sending the number to
SP too quick or too slow?
How do I config to ajust to that? Can anyone in the list share some light?

Thanks a lot.
Michael


On 7/26/05, Michael Jia <michael.mjia at gmail.com> wrote:
> I tried a little more with following extension.conf
> 
> ;dial out
> ignorepat => 9
> exten => _9.,1,Answer
> exten => _9.,2,Dial(Zap/4/${EXTEN:1})
> 
> exten => 100,1,Answer
> exten => 100,2,Dial(Zap/4/2197723)
> 
> dial 100 works fine, my other phone can receive the call.
>  but dial 92197723 doesn't work. In theory, they should be same.
> I even notice in console, asterisk prints same log messages. But the latter
> just hangs after
>  -- Attempting native bridge of Zap/1-1 and Zap/4-1
> and eventually hungup.
> 
> Why?
> 
> Thanks
> Michael
> 
> On 7/25/05, Michael Jia <michael.mjia at gmail.com> wrote:
> > Hi,
> >
> > I am configuring Asterisk with TDM400 card with 1 FXS and 1 FXO
> > module. My first goal is to allow phones to be able to call out
> > through the asterisk PBX.
> >
> > After channels and dial plans setup, Zap/1 connect to phone and Zap/4
> > connect to provider , when I dial the phone, the following message
> > shows in the asterisk console
> >
> > ------------------
> > Starting simple switch on 'Zap/1-1'
> >    -- Executing Dial("Zap/1-1", "Zap/4/9999999") in new stack
> >    -- Called 4/9999999
> >    -- Zap/4-1 answered Zap/1-1
> >    -- Attempting native bridge of Zap/1-1 and Zap/4-1
> >    -- Hungup 'Zap/4-1'
> > -----------------
> > However, there is only 1 ringtone in my phone, and it becomes silent
> > and eventually the call was dropped.
> >
> > But reversely, if i dial my home number from a different phone, i can
> > reach the PBX, and then by dialing an extension, i can ring the local
> > phone without any problem.
> >
> > I only have problem dialing out. What could be the reason?
> >
> > Thanks a lot.
> > Michael
> >
>