[Asterisk-Users] IAXphone -> ip address -> extension number.

Carlos Alperin calperin at senecacom.net
Fri Jul 8 05:58:14 MST 2005 

Zoltan,

Ok. I believe that I know what is going on:

Just for confirm can you go inside the system : run asterisk -r

Then run IAX2 SHOW PEERS and tell me what you get?

When you finish you can exit with quit.

I think that the system doesn't know where are the phones located.

Thanks,

Carlos

-----Original Message-----
From: asterisk-users-bounces at lists.digium.com
[mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of Zoltan Szecsei
Sent: Friday, July 08, 2005 6:17 AM
To: Asterisk Users Mailing List - Non-Commercial Discussion
Subject: Re: [Asterisk-Users] IAXphone -> ip address -> extension number.

Carlos Alperin wrote:

>The only reason for try SIP, is to find where the problem is.
>
>You can use what you prefer, if you can made it works.
>
>Any chance to see both SIP & IAX.conf?
>
>Thanks,
>
>Carlos
>
>  
>
Hi Carlos,
Thanks for you help thusfar.
I have provided:

iax.conf
extensions.conf
bits of log from asterisk -vvvvvvvvvvgc
last bits from making zaptel
modprobe/lsmod ztdummy.

Note that I have renamed zaptel.conf and sip.conf because I am under the 
impression I do not need them. I dont want to add SIP until IAX works, 
and I have no special HW, so dont need zaptel.conf.

Note also at this stage extensions.conf has only what I hope it needs to 
just make the other phone ring.

The SuSE 9.3 box running asterisk 1.0.9 has IP 192.168.0.100 and phones 
z1 and z2 have 192.168.0.201 and 202 respectively.

++++++++++++++++++++++++++++++++++
gl0:/etc/asterisk # cat iax.conf
[general]
port=4569
bindaddr=0.0.0.0
bandwidth=medium
disallow=LPC10
;deny=all
;all0w=ulaw
;all0w=alaw
;all0w=gsm
jitterbuffer=yes

;   register => zoltan:geograph at iaxtel.com


[z1]
type=friend
host=dynamic
mailbox=1201
context=geograph
callerid="Zoltan1" <201>

[z2]
type=friend
host=dynamic
mailbox=1202
context=geograph
callerid="Zoltan2" <202>
gl0:/etc/asterisk #

++++++++++++++++++++++++++++++++++
gl0:/etc/asterisk # cat extensions.conf
[general]
static=yes
writeprotect=no

[globals]
CONSOLE=Console/dsp                             ; Console interface for demo
;CONSOLE=Zap/1
;CONSOLE=Phone/phone0
IAXINFO=guest                                   ; IAXtel username/password
;IAXINFO=myuser:mypass
TRUNK=Zap/g2                                    ; Trunk interface
TRUNKMSD=1                                      ; MSD digits to strip 
(usually 1 or 0)
;TRUNK=IAX2/user:pass at provider

[geograph]
exten=>  201,1,Dial(IAX/z1,20,tr)
exten=>  202,1,Dial(IAX/z2,20,tr)
exten=> 1201,1,Dial(IAX/z1,20,tr) ; not relevant yet
exten=> 1202,1,Dial(IAX/z2,20,tr) ; not relevant yet

++++++++++++++++++++++++++++++++++
 From asterisk -vvvvvvvvvvvvvvvgc


snip===8<===snip===8<===snip===8<===snip===

 [res_musiconhold.so] => (Music On Hold Resource)
  == Parsing '/etc/asterisk/musiconhold.conf': Found
Jul  8 11:58:13 WARNING[32206]: res_musiconhold.c:565 moh_register: 
Unable to open pseudo channel for timing...  Sound may be choppy.
  == Registered application 'MusicOnHold'
  == Registered application 'WaitMusicOnHold'
  == Registered application 'SetMusicOnHold'
 [pbx_config.so] => (Text Extension Configuration)
  == Parsing '/etc/asterisk/extensions.conf': Found
    -- Setting global variable 'CONSOLE' to 'Console/dsp'
    -- Setting global variable 'IAXINFO' to 'guest'
    -- Setting global variable 'TRUNK' to 'Zap/g2'
    -- Setting global variable 'TRUNKMSD' to '1'
    -- Registered extension context 'geograph'
    -- Added extension '201' priority 1 to geograph
    -- Added extension '202' priority 1 to geograph
    -- Added extension '1201' priority 1 to geograph
    -- Added extension '1202' priority 1 to geograph
 [pbx_spool.so] => (Outgoing Spool Support)
 [cdr_csv.so] => (Comma Separated Values CDR Backend)
 [cdr_manager.so] => (Asterisk Call Manager CDR Backend)
  == Parsing '/etc/asterisk/cdr_manager.conf': Found
 [chan_agent.so] => (Agent Proxy Channel)
  == Registered channel type 'Agent' (Call Agent Proxy Channel)
  == Registered application 'AgentLogin'
  == Registered application 'AgentCallbackLogin'
  == Registered application 'AgentMonitorOutgoing'
  == Parsing '/etc/asterisk/agents.conf': Found
 [chan_iax2.so] => (Inter Asterisk eXchange (Ver 2))
Jul  8 11:58:13 WARNING[32206]: chan_iax2.c:7477 load_module: Unable to 
open IAX timing interface: No such file or directory
  == Manager registered action IAXpeers
  == Parsing '/etc/asterisk/iax.conf': Found
  == Registered channel type 'IAX2' (Inter Asterisk eXchange Driver (Ver 2))
  == Using TOS bits 0
  == IAX Ready and Listening on 0.0.0.0 port 4569
  == Loaded firmware 'iaxy.bin'
  == Parsing '/etc/asterisk/iaxprov.conf': Found
    -- Loaded provisioning template 'default'
 [chan_local.so] => (Local Proxy Channel)
  == Registered channel type 'Local' (Local Proxy Channel Driver)


snip===8<===snip===8<===snip===8<===snip===


[chan_sip.so] => (Session Initiation Protocol (SIP))
  == Parsing '/etc/asterisk/sip.conf': Not found (No such file or directory)
Jul  8 11:58:13 NOTICE[32206]: chan_sip.c:8679 reload_config: Unable to 
load config sip.conf, SIP disabled
  == Registered channel type 'SIP' (Session Initiation Protocol (SIP))
  == Registered application 'SIPDtmfMode'
 [chan_skinny.so]Jul  8 11:58:13 WARNING[32206]: chan_oss.c:257 
sound_thread: Read error on sound device: Resource temporarily unavailable
 => (Skinny Client Control Protocol (Skinny))
  == Parsing '/etc/asterisk/skinny.conf': Found
Jul  8 11:58:13 WARNING[32206]: chan_skinny.c:2587 reload_config: Unable 
to get our IP address, Skinny disabled
  == Registered channel type 'Skinny' (Skinny Client Control Protocol 
(Skinny))
 [codec_a_mu.so] => (A-law and Mulaw direct Coder/Decoder)
  == Registered translator 'alawtoulaw' from format alaw to ulaw, cost 1
  == Registered translator 'ulawtoalaw' from format ulaw to alaw, cost 1


snip===8<===snip===8<===snip===8<===snip===

 [app_zapateller.so] => (Block Telemarketers with Special Information Tone)
  == Registered application 'Zapateller'
  == Parsing '/etc/asterisk/enum.conf': Found
  == Parsing '/etc/asterisk/extconfig.conf': Found
  == Parsing '/etc/asterisk/logger.conf': Found
Asterisk Event Logger restarted
  == Parsing '/etc/asterisk/manager.conf': Found
  == Parsing '/etc/asterisk/enum.conf': Found
  == Parsing '/etc/asterisk/rtp.conf': Found
  == RTP Allocating from port range 10000 -> 20000
Asterisk Ready.
*CLI> iax2 show users
Username         Secret                Authen           Def.Context      
A/C 
z2               -no secret-           000000000000003  geograph         
No  
z1               -no secret-           000000000000003  geograph         
No  
*CLI>
*CLI>
*CLI> iax2 show peers
Name/Username    Host                 Mask             Port      Status   
z2               (Unspecified)   (D)  255.255.255.255  0         Unmonitored
z1               (Unspecified)   (D)  255.255.255.255  0         Unmonitored
*CLI>
*CLI>


++++++++++++++++++++++++++++++++++

/usr/src/zaptel-1.0.9 make clean ; make linux26 ; make install

snip===8<===snip===8<===snip===8<===snip===

install tor2 /sbin/modprobe --ignore-install tor2 && /sbin/ztcfg
install torisa /sbin/modprobe --ignore-install torisa && /sbin/ztcfg
install wcusb /sbin/modprobe --ignore-install wcusb && /sbin/ztcfg
install wcfxo /sbin/modprobe --ignore-install wcfxo && /sbin/ztcfg
install wcfxs /sbin/modprobe --ignore-install wcfxs && /sbin/ztcfg
install ztdynamic /sbin/modprobe --ignore-install ztdynamic && /sbin/ztcfg
install ztd-eth /sbin/modprobe --ignore-install ztd-eth && /sbin/ztcfg
install wct1xxp /sbin/modprobe --ignore-install wct1xxp && /sbin/ztcfg
install wct4xxp /sbin/modprobe --ignore-install wct4xxp && /sbin/ztcfg
install wcte11xp /sbin/modprobe --ignore-install wcte11xp && /sbin/ztcfg
install ztdummy /sbin/modprobe --ignore-install ztdummy && /sbin/ztcfg
if ! grep "alias wctdm" /etc/modprobe.d/zaptel; then \
        echo "alias wctdm wcfxs" >> /etc/modprobe.d/zaptel; \
fi \

alias wctdm wcfxs
if [ -d /etc/modutils ]; then \
        /sbin/update-modules ; \
fi
[ `id -u` = 0 ] && /sbin/depmod -a || :
[ -f /etc/zaptel.conf ] || install -D -m 644 zaptel.conf.sample 
/etc/zaptel.conf
gl0:/usr/src/zaptel-1.0.9 #


++++++++++++++++++++++++++++++++++
from modprobe ztdummy and lsmod | grep z

gl0:/usr/src/zaptel-1.0.9 # modprobe ztdummy
Notice: Configuration file is /etc/zaptel.conf
line 142: Unable to open master device '/dev/zap/ctl'
gl0:/usr/src/zaptel-1.0.9 # lsmod | grep z
Module                  Size  Used by
ztdummy                 7744  0
zaptel                239620  1 ztdummy
crc_ccitt               6144  1 zaptel
gl0:/usr/src/zaptel-1.0.9 #

++++++++++++++++++++++++++++++++++


_______________________________________________
Asterisk-Users mailing list
Asterisk-Users at lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users

More information about the asterisk-users mailing list