[Asterisk-Users] line assignment on TDM400P

[Robert Webb]

Try looking in your extensions.conf file. If you are using ports 0 and 2
then you should see somewhere in there something like zap/1 and zap/4
and those should tied to the dial commands. 

Hopefully these have been configure in the globals section of the
extensions.conf. 

I am kind of a newb at this so if this is not clear, feel free to fire
away with questions. 

Robert

-----Original Message-----
From: asterisk-users-bounces at lists.digium.com
[mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of David
Newman
Sent: Monday, January 31, 2005 2:09 PM
To: asterisk-users at lists.digium.com
Subject: [Asterisk-Users] line assignment on TDM400P

Greetings. We are running * on RH9 using a Digium TDM400P four-port FXO 
card. We use only two ports on the card (ports 0 and 2 in this case). A 
consultant set this up for us, and it mostly works OK.

However, outbound calls use our secondary number rather than our primary

number first. This undesirable because of Caller ID; we'd like the
primary 
number to appear instead.

Yes, I can correct this by swapping the PSTN lines. But which config
file 
assigns the physical FXO ports to PSTN lines? In other words, what file 
would I alter to assign different lines to each port?

thanks

dn
_______________________________________________
Asterisk-Users mailing list
Asterisk-Users at lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users