[Asterisk-Users] zaphfc no callerid incoming to SIP phone but visible in logfile

[Michiel van Baak]

> ----- Originele Bericht -----
> Van: Remco Barende
> Aan: Asterisk Users Mailing List - Non-Commercial Discussion 
> Datum: Friday, 21 January 2005, 21:24 
> Onderwerp: Re: [Asterisk-Users] zaphfc no callerid incoming to SIP phone but visible in logfile
> 
> >>> Ive added a ZAPHFC card to my CAPI based system. Calls coming in via
> >>> ZAPHFC do not forward the caller id to the SIP phones. Calls coming in
> >>> via CAPI do forward the caller id to the SIP phones.
> >
> > -- Accepting call from 1729731418 to 807440 on channel 0/1, span 1
> > -- Executing Answer("Zap/1-1", "") in new stack
> > -- Executing SetCIDNum("Zap/1-1", "0") in new stack
> >
> > It does not add the callerid it has two lines above ???
> >
> > I know there have been some changes to the CID structure sometime within 
> > Asterisk. But, this is using the bristuff download and install script.
> 
> This isnt helping much but I am using bristuff too and can confirm the 
> problem. I posted a message about it earlier on the list.
> 
> It seems like a bristuff problem. I have some other problems with bristuff 
> 0.2 too, if the cable is disconnected even briefly from the line in to the 
> Nt1 the line never comes back up. Also, if i restart asterisk I cannot use 
> the line incoming or outgoing. I have to stop *, unload the drivers, 
> re-load the drivers and fire up asterisk again. This too is a problem I 
> have seen reported on the list by others.
> 
> bristuff 0.10 is supposed to be better but has an asterisk from the stone 
> age :)

I see both problems too.
And the reloading of the modules is no option for me neither cause it will crash my server every 2nd reload. I think it has something to do with the partial unloading on SMP modules as stated on the WIKI. The patch listed there isn't fixing it.

Michiel