[Asterisk-Users] TDM400 lost after reboot

[Mark]

Do you have your zaptel drivers set to start when the system is rebooted?
If not, try rebooting and issue the "modprobe zaptel" and "modprobe wctdm"
commands to manually start them.  You could also issue the "lsmod" command
after a reboot to see if zaptel and wctdm are running.  I had problems with
the zaptel startup script, but for whatever reason it works now.

Good luck!

Mark

-----Original Message-----
From: asterisk-users-bounces at lists.digium.com
[mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of
timebandit001 at gmail.com
Sent: Sunday, January 16, 2005 7:38 AM
To: Asterisk Users Mailing List - Non-Commercial Discussion
Subject: [Asterisk-Users] TDM400 lost after reboot


Hi

My card is working, but when I reboot the machine, most of the times it is
not working,

I get "ztcfg: ZT_CHANCONFIG failed on channel 1: No such device or address
(6)"

To make it work again I have to shut down, remove the card, reboot so kudzu
will remove the config. shut down again, put the card back in, reboot, now
kudzu see it, I choose "Ignore" and then it's working again (until the next
reboot).

I'm on WBEL 3.0 and the card is not sharing is IRQ.

Is anybody else having this problem ?

When kudzu see it (as a Jens Schoenfeld Intel 537), what should I choose ?

Is there something I can do to prevent this from happening ?

Thanks
_______________________________________________
Asterisk-Users mailing list
Asterisk-Users at lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users