[Asterisk-Users] Asterisk@Home Install Problems

[Jonathan Curd]

I am trying to install asterisk at home on a Dell 1650
server. The setup cd runs fine and completes with no
errors but when I try to connect to the web site
(http:myip/maint) to edit the configs nothing happens
just a page not found error. 

I'm not sure if there is a problem with my dual on
board nics but when I check ifconfig I see the dhcp
address info that was assigned for eth0 and then
underneath some info about a loop back with the
address 127.0.0.1. (I can ping the address assined
from my other machie but I cannot see the address as
leased in my dhcp server) I can successfully change
the dhcp address to my own config for eth0 using
netconfig but the loop back stuff remains when I use
ifconfig to check the ip. Also I can't ever see the ip
or config the ip on the second ethernet port. In
addition the use of hostnae -i shows an ip of
127.0.0.1. If I use only the ethernet jack 1 and leave
the second jack unplugged same result as above, but if
I use only jack 2and leave jac 1 unplugged I see just
the loopback info and nothing about eth0 with the
defined ip and netconfig does nothing.

Any help getting this up and runnign would be greatly
appreciated.

-Jonathan

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com