[Asterisk-Users] TE410P problem (Looping UP Span 1...)

[Sid]

Hi Scott, and Jack,

--- Scott Stingel <scott at evtmedia.com> wrote:

> Sid-
> 
> Try connecting one port to another.  Note that one of the ports must be 
> set up as "cpe" and the other as "net" in zapata.conf when you loop them 
> together like this.
> 
> A suitable crossover cable for testing can be constructed by cutting up 
> a CAT 5 cable, and connecting:
> Pin 1 <--> Pin 4 on the other end
> Pin 2 <--> Pin 5
> Pin 4 <--> Pin 1
> Pin 5 <--> Pin 2
> 
> You should get green's on both the connected channels if your zaptel and 
> zapata configurations are ok, and if you've run both modprobe and ztcfg 
> as documented.
> 

Thanks for the valuable responses. We can only do the tests on monday, as the machine is
in a data center. Other than that we have done every tests we can think of and found in
the mailing list/wiki. The tests done at the NOC says that T1 is ok at their end. Please
see the following information about the system: 

The machine has 4 Xeon 2.80GHz CPUs.

This is from /proc/interrupts
 16:          0          0          0          3   IO-APIC-level  usb-uhci
 19:          0          0          0          0   IO-APIC-level  usb-uhci
 23:          0          0          0          0   IO-APIC-level  ehci-hcd
 26:     129024          0          0         28   IO-APIC-level  eth1
 27:          0          0      21352          5   IO-APIC-level  eth0
 76:          0          0          0          0   IO-APIC-level  t4xxp

# dmesg
Zapata Telephony Interface Registered on major 196
Specify address with base=0xNNNNN
Registered Tormenta2 PCI
Found TE410P at base address fc8ff800, remapped to f8a40800
TE410P version c01a009b
FALC version: 00000005, Board ID: 00
Reg 0: 0x371c9800
Reg 1: 0x371c9000
Reg 2: 0x07fc07fc
Reg 3: 0x00000000
Reg 4: 0x00000000
Reg 5: 0x00000000
Reg 6: 0xc01a009b
Reg 7: 0x00001000
Reg 8: 0x00000000
Reg 9: 0x00ff0000
Reg 10: 0x00000000
TE410P: Launching card: 0
TE410P: Setting up global serial parameters
Found a Wildcard: Wildcard TE410P-Xilinx
Registered tone zone 0 (United States / North America)
TE410P: Span 1 configured for ESF/B8ZS
SPAN 1: Primary Sync Source

I am doubtful about the interrupts. Are those values ok? We have been after this problem
for more than a week now, we have tested with 2 different cards to no success. 

I'll post the results of the crossover connection test, once we do that. Thanks again for
the responses.

BR,
-Sid


		
__________________________________ 
Do you Yahoo!? 
The all-new My Yahoo! - What will yours do?
http://my.yahoo.com