[Asterisk-Users] AVM C2 capi.conf ?

[Andreas Czerniak]

Hi,

i will use an AVM C2 controller with asterisk.

How can i use both card ports ?? On the voip-info.org Wiki is only notice 
to:

You will need a section for each controller in /etc/asterisk/capi.conf so 
the C2 will have 2 sections.

But how is look like this ?
Only on the first port is asterisk assume connections, but nothing on the 
second card port. In the dmesg is only the capidrv-1 shown, no capidrv-2, 
only the isdnlog is shown the incoming call on the second port.

Has anyone an usable (capi.conf?) configration ?


Thx in advanced and regards,

		Andreas.


-- appendix --
capidrv: Rev 1.1.2.2: loaded
b1: revision 1.1.2.2
ACPI: PCI interrupt 0000:00:09.0[A] -> GSI 5 (level, low) -> IRQ 5
c4: PCI BIOS reports AVM-C2 at i/o 0xd000, irq 5, mem 0xe1000000
kcapi: Controller 1: c2-d000 attached
kcapi: Controller 2: c2-d000 attached
c4: AVM C2 at i/o 0xd000, irq 5, mem 0xe1000000
c4: revision 1.1.2.2
c2-d000: card 1 "C2" ready.
c2-d000: card 1 Protocol: DSS1
c2-d000: card 1 Linetype: point to multipoint
c2-d000: C2-card (3.11-04) now active
kcapi: card 1 "c2-d000" ready.
c2-d000: card 2 "C2" ready.
c2-d000: card 2 Protocol: DSS1
c2-d000: card 2 Linetype: point to multipoint
c2-d000: C2-card (3.11-04) now active
kcapi: card 2 "c2-d000" ready.
capidrv: controller 1 up
capidrv-1: now up (2 B channels)
capidrv-1: D2 trace enabled
capidrv: controller 2 up
capidrv-2: now up (2 B channels)
capidrv-2: D2 trace enabled