[Asterisk-Users] Outbound call on TDM400P

[David J Carter]

Guy,

I think what Lyle meant was to put a wait as in dial -- wait --- number.

Therefore the line is seized and then after a wait the number is dialled.

Dave
  -----Original Message-----
  From: asterisk-users-bounces at lists.digium.com
[mailto:asterisk-users-bounces at lists.digium.com]On Behalf Of Guy C.
Guckenberger
  Sent: 27 February 2005 22:17
  To: Asterisk Users Mailing List - Non-Commercial Discussion
  Subject: RE: [Asterisk-Users] Outbound call on TDM400P


  ok so I put the wait in and still have the same results.

  Extensions.conf
  exten => s,5,SetCallerID(${OUTCID})

  exten => s,6,Wait(2)    <---------------------I added this>

  exten => s,7,Dial(${OUT}/${ARG1})

  exten => s,8,Congestion

  exten => s,107,Macro(outisbusy)





  Im still only getting out every few calls.  Any other suggestions?





  Thanks




----------------------------------------------------------------------------
--
  From: asterisk-users-bounces at lists.digium.com
[mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of Lyle Giese
  Sent: Sunday, February 27, 2005 1:11 PM
  To: Asterisk Users Mailing List - Non-Commercial Discussion
  Subject: Re: [Asterisk-Users] Outbound call on TDM400P


  Put a 'w'ait in your dial command.  * is probably dialing too quickly
after going off-hook.

  Lyle

    ----- Original Message -----
    From: Guy C. Guckenberger
    To: asterisk-users at lists.digium.com
    Sent: Sunday, February 27, 2005 12:00 PM
    Subject: [Asterisk-Users] Outbound call on TDM400P


    Ok all here is a strange one......

    I have a TDM400P with 3 fxo modules.  I can very rarely make an outbound
call to the PSTN....about once every 10 tries.  However if I use a analog
phone pluged into the same phone line as one of the tdm channels say channel
4, and I place the analog phone off hook and then place a call via asterisk
, it work everytime.  It seems like the TDM400p is having trouble grabbing
the outbound circuit.  I have tried  this on all three fxo modules and get
the same results.  Inbound calls work fine as do SIP calls.  Anyone else run
into this?  Maybe I have bad hardware?



    Thanks


----------------------------------------------------------------------------


    _______________________________________________
    Asterisk-Users mailing list
    Asterisk-Users at lists.digium.com
    http://lists.digium.com/mailman/listinfo/asterisk-users
    To UNSUBSCRIBE or update options visit:
       http://lists.digium.com/mailman/listinfo/asterisk-users
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-users/attachments/20050227/57fd95c1/attachment.htm