[Asterisk-Users] Help With Adit 600 Configuration

Andrew Kohlsmith akohlsmith-asterisk at benshaw.com
Wed Feb 23 07:11:24 MST 2005


On February 23, 2005 07:51 am, Etoenyo Ntumi wrote:
> ;)  thanks Andrew, and I do take the reprimand in good faith. I am using
> the Usual Cisco type roll-over cable.

Nope this isn't Cisco gear.  You want a regular 9-pin serial cable ("straight 
through").

> When you say "regular" do you mean straight through ?,  and can you kindly
> confirm for me if the HyperTerminal settings I am using are OK?. I am
> definitely not using a null-modem cable, and yes the port works cos I use
> it every day on various Cisco gear

Those settings (9600n81) are fine.  No flow control.

> I have called Carrier Access, I am just waiting for them to get in to the
> office, so I can register, any help in the mean time is still very much
> appreciated though

Good good.  Basically what you do on an Adit600 is "connect" T1 channels to 
card channels.  There are two T1s, and up to 6 cards.  Each card has 8 
channels, so the typical connection is something like this:

connect a:1:1-8 1:1-8

that connects T1#1 (whcih is in slot 'A') channels 1-8 to card #1's channels 
1-8.

There is pretty good context-sensitive help built in.  Just type ? where you 
want help.   Also don't forget to set the clocking and framing or you'll 
likely get frame slips and odd little behaviours.

-A.



More information about the asterisk-users mailing list