[Asterisk-Users] Adtran Total Access MGCP Config?

[Dave Weis]

I've never set up an mgcp device before. I have an Adtran IAD with the 
MGCP firmware on it. I have it configured in mgcp.conf like this:

[general]
port = 2427
bindaddr = 0.0.0.0

[adtran]
host = 192.168.2.2
context = default
canreinvite = no
line => aaln/1
line => aaln/2

The device is configured like this:

MGCP Configuration  | Standard          MGCP 0.1 / NCS 1.0
MGCP Endpoint Config| MGC Address       192.168.1.253
                     | Local Address     192.168.2.2
                     | MGC UDP Port      2727
                     | Local UDP Port    2427
                     | ADPCM Coding      IETF (RTP)
                     | RFC 2833          RTP Payload Type 94
                     | DSCP Signaling    0
                     | DSCP RTP Traffic  0
                     | Advanced Config   [+]

I can ping between the devices fine. Doing an
mgcp audit endpoint aaln/1 at adtran gives retransmitting errors. tcpdump 
shows traffic over the wire.

dave

-- 
Dave Weis             "I believe there are more instances of the abridgment
djweis at sjdjweis.com   of the freedom of the people by gradual and silent
                       encroachments of those in power than by violent
                       and sudden usurpations."- James Madison