[Asterisk-Users] Asterisk@Home .5 Setup help with 4 X100P {Scanned}

[Rich Adamson]

> I removed the ; before channel => 1 and restarted * and I get an error.
> 
> Ouch ... error while writing audio data: : Broken pipe
> 
> ?????
> 
> I then replaced the ; and its starts??
> 
> I'm upgrading from .4 to .5
> 
> .4 was running
> 
> Thanks, David
> 
> 
> 
> On Tue, 2005-02-15 at 12:46 -0500, dean collins wrote:
> > David,
> > You will need to go into the Zapata.conf file and remove the ; before
> > channel => 1
> > 
> > (modify it to suit however you want to set up your 4 X100p lines.
> > 
> > The outgoing lines you see in FOP are only example lines, you will need
> > to modify FOP to get rid of them etc.
> > 
> > 
> > -----Original Message-----
> > From: asterisk-users-bounces at lists.digium.com
> > [mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of David Shaw
> > Sent: Tuesday, February 15, 2005 11:02 AM
> > To: Asterisk Users Mailing List - Non-Commercial Discussion
> > Subject: [Asterisk-Users] Asterisk at Home .5 Setup help with 4 X100P
> > 
> > Hello All, I installed Asterisk at Home .5 last night. I was able to
> > configure some extensions for the house and they work fine. I just can't
> > make inbound and/or outbound calls. The Flash Operator Panel shows four
> > external icons and my new extensions. 
> > 
> > I have four X100P and two Broadvoice sip accounts.
> > 


The broken pipe message usually means something is misconfigured. Check
your zapata.conf against the following:

context=inbound-bus
signalling=fxs_ks
echocancel=yes
echotraining=800
echocancelwhenbridged=no
rxgain=3.0
txgain=0.0
immediate=yes
channel => 1

After making changes to zapata.conf, be sure to stop and start *.
Don't use reload on these type changes.