[Asterisk-Users] Problems setting up X100 FXO card

[Marek Zachara]

Hi,

I'm trying to configure a clone of X100 for use with asterisk, but i have 
reached the zaptel.conf step and have not been able to progress further 
as i'm getting the following error:

arnor:~# ztcfg -v

Zaptel Configuration
======================


Channel map:

Channel 01: FXS Kewlstart (Default) (Slaves: 01)

1 channels configured.

ZT_CHANCONFIG failed on channel 1: Invalid argument (22)
Did you forget that FXS interfaces are configured with FXO signalling
and that FXO interfaces use FXS signalling?


i was not able to make it work, trying other setups (fxsls, fxsgs, even 
fxo... )
please help me sort it out or point out what i'm doing wrong :(

thanks,
Marek


-------------------------------------------------
here is output from kernel/dmesg:

Aug 24 16:11:13 arnor kernel: Zapata Telephony Interface Registered on major 
196
Aug 24 16:13:32 arnor kernel: ACPI: PCI Interrupt 0000:02:0c.0[A] -> GSI 20 
(level, low) -> IRQ 20
Aug 24 16:13:32 arnor kernel: wcfxo: DAA mode is 'FCC'
Aug 24 16:13:32 arnor kernel: Found a Wildcard FXO: Generic Clone
Aug 24 16:13:32 arnor kernel: Registered tone zone 0 (United States / North 
America)

output of lspci (partial):
0000:02:0c.0 Communication controller: Tiger Jet Network Inc. Tiger3XX 
Modem/ISDN interface

output of lsmod:
Module                  Size  Used by
wcfxo                  13088  0
zaptel                223620  5 wcfxo

here is contents of /etc/zaptel.conf:
#
# Zaptel Configuration File
#
fxsks=1

loadzone = us
defaultzone=us