[Asterisk-Users] bri error

[Altus Snyman]

and I have 
signalling = bri_cpe_ptmp


On Fri, 2005-04-29 at 12:14, David Masure wrote:
> Did you put your card in TE mode ?
> 
> To it seems you have configured your card to act like a NT but if you
> are connected to bri telco lines, it should be in TE mode
> 
> check in your zaptel.conf : bri te signalling
> 
> regards
> 
> David
> 
> 
> 
> -----Message d'origine-----
> De : Altus Snyman [mailto:altus at stormcorp.co.za]
> Envoyé : vendredi 29 avril 2005 12:08
> À : Asterisk Users Mailing List - Non-Commercial Discussion
> Objet : [Asterisk-Users] bri error
> 
> 
> Good day all
> This is a error that keeps on popping up in my /var/log/messages when I
> get incoming or outgoing calls on my bri card connected to 4 telco isdn
> units?It is a junghanns 4 port card with the latest version of the
> drivers and latest asterisk
> Apr 29 11:37:39 ccv kernel: qozap: BAD CRC for hdlc frame on card 1
> (cardID 0) S/T port 1
> Apr 29 11:37:39 ccv kernel: qozap: check the 100 Ohm termination for
> this span!
> Apr 29 11:45:25 ccv kernel: zaptel Disabled echo canceller because of
> tone (rx) on channel 1
> 
> Please help and advice?
> 
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-users
>