[Asterisk-Users] broadvoice config problem.

[Rich Adamson]

> > On Apr 11, 2005 3:58 PM, Craig Simon <linux at craigsimon.net> wrote:
> > > This is the pieces of my extensions.conf.  All this has been sent to me
> > > from broadvoice, so I can't tell you if it's correct or not.  I do have
> > > an extension 100 created, and that is what I am logging on with my
> > > softphone as.  And testing my outgoing calling.
> > > 
> > > Thanks for the help!
> > > Craig
> > > 
> > > [from-broadvoice]
> > > exten => s,1,Answer
> > > exten => s,2,Wait(1)
> > > exten => s,3,Dial(LOCAL/100 at default,25)
> > > ;exten => s,3,Goto(ivr,1,1)
> > > exten => s,4,VoiceMail(u${EXTEN}@default)
> > > exten => s,5,Hangup
> > 
> > This is wrong.  's' is only used if * doesn't detect what number was
> > called, which in this case it has (100).  So the end result is that
> > nothing in your dialplan matches which results in the 404 not found.
> > 
> > Replace 's' with '100' and I think it will work.
> 
> If that doesn't fix the problem, then do another sip debug and post
> the results.
> 
> It would be much easier to help if you posted:
>  1. the register statement in sip.conf (change any passwords in it)
>  2. the context that you're using to receive calls from broadvoice
>     in sip.conf (you probably have a context like [broadvoice].)
>  3. the extension.conf entries for sending calls to broadvoice, and
>     the entries for receiving calls (after you make the above changes).
> 
> >From your previous debug posting, it looked like you might also have
> an issue with exactly which codec is to be used. If the above doesn't
> fix all the problems, then consider adding the following towards the
> top of your sip.conf file (in the [general] section):
>  disallow=all
>  allow=ulaw

Ops, just noticed you _did_ post the sip.conf stuff in an earlier
post. Sorry.
Add the disallow=all and allow=ulaw to the [sip.broadvoice.com]
context in sip.conf.