[Asterisk-Users] (newbie) no dialtone on a TDM400P card

[Thomas Andrews]

On Sun, Nov 14, 2004 at 04:06:37PM +0100, Soren Rathje wrote:

> modprobe zaptel debug=1

 kernel: Zapata Telephony Interface Registered on major 196

> insmod wctdm debug=1

 kernel: Setting FXS hook state to 0 (00)
 last message repeated 3 times
 kernel: Registered Span 1 ('WCTDM/0') with 4 channels
 kernel: Span ('WCTDM/0') is new master
 kernel: Freshmaker version: 71
 kernel: Freshmaker passed register test
 kernel: ProSLIC on module 0, product 0, version 5
 kernel: ProSLIC on module 0 seems sane.
 kernel: ProSLIC on module 0 powered up to -72 volts (c2) in 20 ms
 kernel: Loop current set to 20mA!
 kernel: Post-leakage voltage: 25 volts
 kernel: ProSLIC on module 0 powered up to -72 volts (c0) in 10 ms
 kernel: Loop current set to 20mA!
 kernel: Calibration Vector Regs 98 - 107: 
 kernel: 98: 10
 kernel: 99: 11
 kernel: 100: 11
 kernel: 101: 0f
 kernel: 102: 07
 kernel: 103: 64
 kernel: 104: 09
 kernel: 105: d7
 kernel: 106: 07
 kernel: 107: 08
 kernel: Init Indirect Registers completed successfully.
 kernel: Proslic module 0 loop current is 20mA
 kernel: Module 0: Installed -- AUTO FXS/DPO
 kernel: ProSLIC on module 1, product 0, version 0
 kernel: VoiceDAA System: 04
 kernel: ISO-Cap is now up, line side: 03 rev 03
 kernel: Module 1: Installed -- AUTO FXO (FCC mode)
 kernel: ProSLIC on module 2, product 0, version 0
 kernel: Module 2: Not installed
 kernel: ProSLIC on module 3, product 0, version 0
 kernel: Module 3: Not installed
 kernel: Found a Wildcard TDM: Wildcard TDM400P REV E/F (4 modules)
 kernel: NO BATTERY on 1/2!

> /sbin/ztcfg

 kernel: Setting FXS hook state to 0 (00)
 kernel: Registered tone zone 0 (United States / North America)
 kernel: Power alarm on module 1, resetting!
 last message repeated 9 times

> asterisk -vvvvvvvgc

 kernel: Setting FXS hook state to 0 (00)
 kernel: Setting FXS hook state to 0 (00)

I don't like the look of that "NO BATTERY" message. What do you think
Soren ?

-Thomas