[Asterisk-Users] CAPI / Channels

[Thorsten Huber]

Hi,

On Thu, May 27, 2004 at 03:53:08PM +0200, Wolfgang Pichler wrote:
> > ...
> > > Here is my actual config (capi.conf)
> > ...
> > > [interfaces]
> > > isdnmode=ptmp
> > > msn=073266xxxx
> > 
> > in my setup I'm using only the localpart as msn without the long
> > distance dial prefix. Did you try this?
> yep - i already tryied this - didn't worked either. Does at your config
> the command "show channels" show you the capi channels ?

show channels shows only active channels. 

Without active calls there are no visible channels:

asterisk*CLI> show channels
        Channel  (Context    Extension    Pri )   State Appl.         Data
0 active channel(s)
asterisk*CLI> capi info
Contr1: 2 B channels total, 2 B channels free.

With an active call from ISDN to some SIP phones show channels shows
the following output:

asterisk*CLI> show channels
        Channel  (Context    Extension    Pri )   State Appl.         Data           
 SIP/96633-d4ca  (from-sip                1   )      Up Bridged Call  CAPI[contr1/966xxxx]/0
CAPI[contr1/966xxxx]/0  (thorsten   s            1   )      Up Dial          SIP/96631&SIP/96632&SIP/96633
2 active channel(s)
asterisk*CLI> capi info
Contr1: 2 B channels total, 1 B channels free.

Have you tried "debug capi"?

-- 
Gruss / Best regards  |  LF.net GmbH        |  fon +49 711 90074-414
Thorsten Huber        |  Ruppmannstrasse 27 |  fax +49 711 90074-33
th at LF.net             |  D-70565 Stuttgart  |  http://www.lf.net