[Asterisk-Users] high pitched tone and message on answer

[Dan Cunningham]

 By the way  the error I'm getting in debug mode

Starting simple switch on 'Zap/1-1'
May 25 21:51:36 WARNING[327700]: chan_zap.c:4871 ss_thread: CallerID
returned with error on channel 'Zap/1-1'

Can anyone help?
Dan

-----Original Message-----
From: Dan Cunningham
To: 'asterisk-users at lists.digium.com'
Sent: 5/25/2004 9:38 AM
Subject: [Asterisk-Users] high pitched tone and message on answer

Hi, I can dial in from pots using a single port analog fxs card once,
but if
I hang up and dial again within 10-20 seconds, I get this high pitched
tone
then a message to enter digits.  I had assumed this was the privacy
feature,
but I don't have it enabled in my extensions.  What could be causing
this?
Also if I dial in again its fine, then not, then fine, etc.....  I
noticed
in debuging that all calls are exiting with a status "exit non zero",
this
includes internal calls (sip to sip, fxo to anything ), and external
calls
(fxs to anything), is this normal (no other errors reported). In my
extentions I always have s=>h,1,Hangup and s=>i,1,Hangup to always
disconnect the line if that matters.
Thanks 
Dan 
_______________________________________________
Asterisk-Users mailing list
Asterisk-Users at lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users