[Asterisk-Users] Asterisk Causing Cisco 7200 Router to Crash?

[Harold Workman]

As far as loosing the configuration...the only reason I could see that
happening is if you either are doing one of the two...   not saving the
configuration...or you have the configuration register set to something like
0x2142.  look on show version for the configuration register.  it should be
0x2102.   And again, i would look for tracebacks...it could either be a
memory issue or a bug in the IOS.  But you will know if you get console
access to the router as u bring up the asterisk...




-----------------------
Harold Workman
CCNA, CCNP
Cytel Communications
hworkman at cytelcom.com
Ph. 281-449-4000 x3098



asterisk-users-admin at lists.digium.com wrote:
> IOS version 12.xx
>
> As far as a traceback, that's going to be difficult now since we've
> removed it from our switch and brought it back here to the office for
> testing. When we test it tomorrow or later in the week, I'll see if
> it crashes again in a test setting and try to get a traceback to the
> list.
>
> It is a Cisco 7206 and all the computers connect via IP.
>
> On Yaum al-Arbi'a 12 Jumaada al-Awal 1425 05:16 pm, Harold Workman
> wrote:
>> asterisk-users-admin at lists.digium.com wrote:
>>> Hi,
>>>    We are having an issue here. It seems that whenever we initialize
>>> Asterisk on our network, the router that the Asterisk server is
>>> connected to (Cisco 7200) crashes and loses it configuration. This
>>> has happended five times and each time we have tested it, it is
>>> always when Asterisk starts up. Has anyone else seen this problem?
>>> It is very odd because this is a very good router and we had the
>>> Asterisk server on an exact same router but different network before
>>> and it did not cause a crash. We have gone through two different
>>> Cisco 7200 series routers and both exhibited the same problems. Any
>>> clues? Thanks -
>>>
>>>
>>> --
>>
>> Brian,
>>
>>
>> Did you log into the Cisco console and watch the cause of the crash?
>> You should be getting a traceback. Or after the router crashes and
>> reloads look at show version.  Could you give a little better
>> explanation of your network as well.  Are you conecting to the 7200
>> via serial or ip? sip?
>>
>>
>> -----------------------
>> Harold Workman
>> CCNA, CCNP
>> Cytel Communications
>> hworkman at cytelcom.com
>> Ph. 281-449-4000 x3098
>>
>> _______________________________________________
>> Asterisk-Users mailing list
>> Asterisk-Users at lists.digium.com
>> http://lists.digium.com/mailman/listinfo/asterisk-users
>> To UNSUBSCRIBE or update options visit:
>>    http://lists.digium.com/mailman/listinfo/asterisk-users
>
> --