[Asterisk-Users] Dell 400SC and X100P

[Martin List-Petersen]

Is your kernel ACPI enabled ?

The motherboard in the PE400SC is basically the Dimension 8300, which i
use for my development box with 1 X101P, 1 TDM400P and two ISDN cards
here at home and that works without problems.

One thing to make sure with these boards is that ACPI is enabled, since
they are ACPI only.

Kind regards,
Martin List-Petersen


On Thu, 2004-06-24 at 02:58, Isamar Maia wrote:
> I have a Dell PowerEdge 400SC with a X100P and a TDM01b.
> The board works wonderfully in another machine but in this brand new one,
> it just get in nuts.
> 
> The problem is:
> 
> 1) Zaptel recognizes it perfectly
> 2) No IRQ conflicts, two-wire new cable.
> 3) Asterisk starts up and listen the ring and answer the cal
> 4) RIght after answering the call, it's dropped.
> 5) The following calls, even with asterisk off, the driver(???) answers
> the call and hang it up. With the * running, it doesn't even get any ring,
> and the call is answered and dropped right away.
> 
> Isamar
> 
> 
> 
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-users