[Asterisk-Users] integrating with existing PBX

[Steve Totaro]

Here is a good place to look.  You either need analog FXO or FXS ports.

http://www.voip-info.org/wiki-Asterisk+legacy+integration

I also have a little info on my site.

http://www.totarotechnologies.com/Articles/General_VoIP_(Voice_over_IP)/Are_you_looking_for_an_affordable_way_to_add_VoIP_capabilities_to_your_existing_PBX_phone_system?/28/



Thanks,

Steve Totaro

Totaro Technologies, Inc.

410.985.7114

----- Original Message ----- 
From: "Florin Andrei" <florin at andrei.myip.org>
To: <asterisk-users at lists.digium.com>
Sent: Monday, June 21, 2004 3:19 PM
Subject: [Asterisk-Users] integrating with existing PBX


> I'm looking for a way to give VoIP capabilities to an existing PBX: it's
> made by Mitel and it's used in a small/medium environment (a few dozen
> phones, but the PBX has capabilities for up to 200, if i remember
> correctly).
>
> Any high-level guidelines on how to integrate Asterisk with a PBX that's
> already in use? Probably that particular PBX is not supported directly,
> but are there ways to somehow hook-up to it and route calls from IP to
> PBX or back?
>
> Entirely replacing the existing PBX with Asterisk is probably out of
> question, for reasons that dip a bit into the non-technical realm. :-)
>
> Thanks in advance,
>
> -- 
> Florin Andrei
>
> http://florin.myip.org/
>
>
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
> To UNSUBSCRIBE or update options visit:
>   http://lists.digium.com/mailman/listinfo/asterisk-users
>