[Asterisk-Users] DTA-310 Outbound Dialing

[Jeremy Jones]

Hi folks,

OK...  I've successfully managed to get a DTA-310 from 8x8 to take
inbound calls from the PSTN, into an AS5300, through asterisk.  I can
call the number associated from out there in the world, it rings, & I
can speak to the person on the other end just fine.  However, I cannot
seem to figure out how to place a call outbound through it.  I do have
outbound calling working fine with another SIP client, X-lite, so I'm
pretty sure it's not my * setup -- I'm willing to share configs, though,
if anyone thinks that'd help.  This DTA-310 runs firmware version "DTA
version 1.0 US (8x8 001111)" as shown on the web interface homepage,
which is the only version of the firmware (that I'm aware of) that
allows tinkering with the SIP settings.

I _think_ my problem has to do with the "Dial Plan" settings on the SIP
configuration page.  Anyone familiar with these things?  By default, the
dial plan setting reads: "1xxxxxxxxxx|x.T".  Using this, or anything
else I've experimented for that matter, I pick up the handset, dial some
numbers, watch the asterisk console, and hear/see nothing.  Dead air on
the handset, & no scrolling gibberish on the * console.

Anyone have ideas?

Thanks,
Jeremy Jones