[Asterisk-Users] TDM400 problem

[Steven P. Donegan]

Mamadou Lamine KA wrote:

>As you have a TDM400 you should load wcfxs module ( modprobe wcfxs or
>modprobe wctdm for new versions) regardless to modules you have installed on
>your board. You should also check the signalling specified in zaptel.conf
>according to your modules and the order they are placed on your TDM400.
>
>Best regards
>Lamine
>
>----- Original Message -----
>From: "Steven P. Donegan" <steve at donegan.org>
>To: <asterisk-users at lists.digium.com>
>Sent: Monday, December 27, 2004 6:01 PM
>Subject: [Asterisk-Users] TDM400 problem
>
>
>  
>
>>I recently swapped 2 FXO modules on to what had previously been a 4 FXS
>>version of the TDM400 board. The FXS ports are recognized - the FXO
>>ports don't appear to be recognized (ie modprobe wcfxo and ztcfg both
>>say channel 1 isn't there). Has anyone experienced this problem? All
>>software is current as of this AM. If the old FXS modules are
>>re-installed all works just dandy (other than the fact that I need the 2
>>FXO ports)...
>>
>>Thanks!
>>
>>_______________________________________________
>>Asterisk-Users mailing list
>>Asterisk-Users at lists.digium.com
>>http://lists.digium.com/mailman/listinfo/asterisk-users
>>To UNSUBSCRIBE or update options visit:
>>   http://lists.digium.com/mailman/listinfo/asterisk-users
>>
>>    
>>
>
>
>_______________________________________________
>Asterisk-Users mailing list
>Asterisk-Users at lists.digium.com
>http://lists.digium.com/mailman/listinfo/asterisk-users
>To UNSUBSCRIBE or update options visit:
>   http://lists.digium.com/mailman/listinfo/asterisk-users
>
>
>
>  
>
modules are FXO and FXS - zapata.conf says fxoks=1-2 and fxsks=3-4

TDM is older unit with no apparent external power connectors (well, not 
a disk drive type one anyway) and no external power was required to use 
the FXS ports in the past...