[Asterisk-Users] Connecting Siemens HiCom PBX with Asterisk through E1

[richard Coco]

richard Coco <coco_richard at yahoo.com> wrote:
Peter Svensson <psvasterisk at psv.nu> wrote:

On Sun, 19 Dec 2004, Jens Kübler wrote:

> I've bought the Wildcard TE110 some days ago but I'm unable to get it to work 
> with Siemens HiCom 300.
> 
> I've tried this so far:
> 1. I've used standard cat5 cable cut off on one edge and twisted wires 1 to 4 
> and 2 to 3 which is according to cisco a short circuit for E1 lines. Wildcard 
> takes a few seconds and sets the link to green (OK).

It should be 1 to 4 and 2 to 5, not 3. The pairs are 1-2 and 4-5.


Hi,
Using a DIUS2 on the Hicom, you have to loop 3-10 and 7-14.   .
Using a DIUN2 on the Hicom, the loop is not necessary.
 
BTW 1-9 is Tx and 7-14 is RX.
 
sorry... 1-9 Tx and 8-15 Rx!!!! (not 7-14)
 
hope it will help.


> 2. I've tried to connect our running E1 line from the telco with wildcard. The 
> modem (modulates HDSL to G703 120 Ohms). I've used a 1:1 cable that did not 
> work. I even tried to connect the copper wires by hand which resulted that 
> the modem gave me a green power light but Wildcard stayed on a waving red 
> light.

That should have worked, as long as 1-1, 2-2, 4-4 and 5-5. Are you sure 
the signalling is correct? What did zttool say?

> 3. I have plugged out our running PBX and connected it to Wildcard which 
> resulted in a green light for one second and then the state from zttool 
> switched to yellow (and Wildcard to constant red light).

Yellow alert is remote alert, right? That would indicate that the path 
from the pbx to asterisk is ok, but not the path from asterisk to the pbx.

> The protocol used by the modem is hdb3 and /etc/zaptel.conf is adjusted 
> according to this.

Do you have crc4 enabled? Care to post your zaptel.conf.

I think you have to start asterisk on the span to get the upper layers 
enabled.

Peter


_______________________________________________
Asterisk-Users mailing list
Asterisk-Users at lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users




---------------------------------
Do you Yahoo!?
Read only the mail you want - Yahoo! Mail SpamGuard._______________________________________________
Asterisk-Users mailing list
Asterisk-Users at lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users

		
---------------------------------
Do you Yahoo!?
 Yahoo! Mail - Easier than ever with enhanced search. Learn more.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-users/attachments/20041221/d58656b5/attachment.htm