[Asterisk-Users] Firewall traversal anomalies - AJA

[Craig Waddington]

It's the RTP Stream

Asterisk by default uses ports UDP 10,000 to 20,000

RTP = Audio

Open them on your firewall.



-----Original Message-----
From: asterisk-users-bounces at lists.digium.com
[mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of Andrew
Aken
Sent: 07 December 2004 15:21
To: Asterisk Users Mailing List - Non-Commercial Discussion
Subject: [Asterisk-Users] Firewall traversal anomalies - AJA

I'm trying to setup a Cisco ATA 186 which has a public IP address but 
sits behind a firewall and connects to an Asterisk server with a NAT IP 
address sitting behind a BSD firewall. The Cisco registers with the 
Asterisk server without any problems, and I can place calls without any 
problems and the phone on the other end rings correctly. However, I 
cannot hear anything through the Cisco after the connection is made. 
Where should I begin looking for the problem?

This is the sip.conf entry for the Cisco:
[6184341501]
callerid="GlobalEyes" <6184341501>
canreinvite=no
context=from-internal
dtmfmode=rfc2833
host=dynamic
mailbox=xxxxx
nat=yes
port=5060
secret=xxx
type=friend
username=xxxxx
allow=all


_______________________________________________
Asterisk-Users mailing list
Asterisk-Users at lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users