[Asterisk-Users] Dial Command M(x) Option

[Alex Barnes]

> -----Original Message-----
> From: Shaun Tierney [mailto:stierney at prairiestream.com] 
> Sent: 02 December 2004 22:37
> To: Asterisk Users
> Subject: [Asterisk-Users] Dial Command M(x) Option
> 
> 
> http://lists.digium.com/pipermail/asterisk-users/2004-October/
> 065540.html


I never did find a solution to the above problem!
So if you / anyone does I would be very interested.


> 
> I saw this post about the M(x) option for the Dial command, 
> but I could not find a reply questions posed here.  I am 
> wanting to pass the Zap channel that the original call came 
> from to my macro embedded in the Dial command. I've tried to 
> add arguments to the macro by using the syntax M(x,arg1), and 
> I always get the following errors.
> 
> Dec  2 15:57:53 WARNING[96234416]: app_dial.c:629 dial_exec: 
> Could not find macro to which we should jump. Dec  2 15:57:53 
> WARNING[96234416]: app_dial.c:636 dial_exec: Macro flag set 
> without trailing ')
> 
> Is there a patch that would allow me to do this?  Or is there 
> a way to get the Zap channel name that requested the Dial on 
> the outbound trunk from within the macro?
> 
> Regards,
> 
> Shaun Tierney
> 


This email and any attached files are confidential and copyright protected.  If you are not the addressee, any dissemination, distribution or copying of this communication is strictly prohibited.  Unless otherwise expressly agreed in writing, nothing stated in this communication shall be legally binding.