[Asterisk-Users] TE410P - ZT_CHANCONFIG failed

[Martin List-Petersen]

Hi,

you can also load the wct4xxp driver with

modprobe wct4xxp t1e1override=1

Does the same job, remotely.

Kind regards,
Martin List-Petersen

On Fri, 2004-08-20 at 22:11, Arnaud Pignard wrote:
> Ok, i haven't get in hand the card and make remote hardware install.
> 
> It's certainely the problem.
> 
> Thanks !
> 
> At 22:49 20/08/2004, you wrote:
> >On Fri, 20 Aug 2004, Arnaud Pignard wrote:
> >
> > > I try setup a TE410P. Already setup E100P without problem. I also check
> > > sample zaptel.conf config in mailing list and seems my config is ok.
> > > However when i modprobe wct4xxp, here is error output :
> > >
> > > ZT_CHANCONFIG failed on channel 97: No such device or address (6)
> > > FATAL: Error running install command for wct4xxp
> >
> >Have you configured the spans for E1 signalling? It sound like you have
> >them set for T1 signalling (24*4=96). You should check the jumpers on the
> >card.
> >
> >Peter
> >
> >
> >_______________________________________________
> >Asterisk-Users mailing list
> >Asterisk-Users at lists.digium.com
> >http://lists.digium.com/mailman/listinfo/asterisk-users
> >To UNSUBSCRIBE or update options visit:
> >    http://lists.digium.com/mailman/listinfo/asterisk-users
> 
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-users