[Asterisk-Users] T1 Line install.. (UK Muppet)
David Stubbs
david.stubbs at idessa.com
Thu Apr 15 07:36:33 MST 2004
Hi all, Muppet from the UK asking for help
We are just about to have a T1 line installed in our office in Dallas
and "Advantex" the supplier has sent a questionnaire asking a number of
questions. I have put the question area at the bottom of the email, we
will be using Digium's hardware. could anybody help :-)
In the UK when I asked for a E1, number of trunks required and the
number of DID numbers, then they stick the socket on the wall! No mass
question... I feel I'm a little out of my depth.
Thanks in Advance for any help.
David Stubbs
============= Questionnaire Follows =================
1. DS1 Facilities Required:
- Superframe or Extended (ESF/SF)?
- Line Coding (B8ZS,AMI,. Etc.)?
- Number of DS1 facilities required?
- Channel numbers used for this trunk group?
2. Circuit Signaling (DS0 or DS1 Signal):
DSO Analog Line Trunk Interface
2 wire, 4 wire, (or "na", not applicable)?
- Supervision
Loop Start, Ground Start, Reverse Battery, E & M
"DNIS - Dialed Number Identification service"
Not applicable with DS0 Analog Line trunks.
DS1 Digital Signal : Digital Interface
- Supervision
Loop Start, Ground Start, E & M
- In-Band or Robbed Bit (E&M) signaling? (Y/N)
- CO Supplied Dial tone (Y/N)
DS1 Digital Signal: ISDN PRI Only
- Primary Rate Interface (ISDN PRI)
- If multiple DS1s, Does the customer want
"Non-Facility Associated Signaling"? (NFAS) (Y/N)
If No, Does the customer want One D-Channel per DS1,
or 1 D-Channels for all DS1s. How many D-Channels?
If NFAS=Yes, Number of D-Channels Required "TWO"
- (PRI ISDN Protocol)= example National PRI (NIPRI)
NIPRI, NTNAPRI, U449PRI, U459PRI, N449PRI
3. Trunk Group Billing Telephone Number (10 digit):
4. Trunk Group Originating Area Code for PBX
5. Calling Scope (Basic, Basic+, Extended, Metro, Metro+)?
6. Primary Interexchange Carrier (PIC)
7. NPA/NXX Call Blocking ( 700, 900, 976)
8. Trunk Group Directional call flow and Member numbering:
(If sub-grouped, select subgroup rollover)
- 2-Way, 1-Way Into PBX, or 1-Way Out of PBX
- Member Numbering (i.e. 0001 thru 0024)
9. Trunk Member selection
- Selection for calls originating at the PBX toward the Central Office
(CO)
Asending (ASEQ), Desending (DSEQ), Most Idle (MIDL), Least Idle
(LIDL)
- Selection for calls terminating to the PBX from the Central Office
(CO)
Asending (ASEQ), Desending (DSEQ), Most Idle (MIDL), Least Idle
(LIDL)
10. Direct Inward Dial to PBX - DID (Y/N):
- Number or Number Blocks routed toward PBX (i.e. 972-668-20xx)
- Porting Coordination Required (Y/N)?
- Number of digits to outpulse (None, 4, 7, 10 digits) to PBX?
11. Inband Ringing required from the CO when terminating calls to PBX
(Y/N)?
12. NON-PRI DS1Switching - Start Signaling and Digit Pulsing for
In-Band
Signaling for NON-PRI DS1:
- CO Incoming Start Signaling for calls originating at the PBX
(ISTARTSG)
Start Signal expected by the PBX, sent by the CO telling the
PBX to begin sending digits to the CO for collection.
- Wink Start, Delay Dial, Immediate Dial, Dialtone, Loop Start,
Grd Start
- CO Incoming Digit Pulsing for calls originating at the PBX (IPULSTYP)
Type of digits sent from the PBX to CO after the PBX
receives the start signal (ISTARTSG) from the CO
- Dial Pulse, DT/ DTMF, MF, NP/No Pulsing
- CO Outgoing Start Signaling for calls terminating to the PBX
(OSTARTSG)
Start Signal expected by the CO, sent by the PBX telling the
CO to begin sending digits to the PBX for collection.
- Wink Start, Immediate Dial, Delay Dial, Loop Start, Grd Start
- CO Outgoing Digit Pulsing for calls terminating to the PBX (OPULSTYP)
Type of digits sent from the CO to the PBX after the CO
receives
the start signal (OSTARTSG) fom the PBX
- Dial Pulse, DT/ DTMF, MF, NP/No Pulsing
13. Manufacturer & Model of PBX.
*** I know this One :o) ***
============ END OF Questionnaire ==================================
More information about the asterisk-users
mailing list