[Asterisk-Users] Problem with T100P card in a new chassis

[WipeOut]

John Todd wrote:

>
> Due to some failed hardware on another platform, I've had to move a 
> T100P card to a different chassis.  After this move was completed, I 
> am seeing some strange results on the T100P card that do not display 
> to me any failure mode with which I am familiar.  The card comes up, 
> and shows "good" carrier and status, but Asterisk refuses to bring the 
> D-channel up.  Calls of course do not complete, inbound or outbound.  
> The configuration on the system is identical to what I had on the same 
> PRI before I disconnected it.  The PRI checks out clean when connected 
> to another Asterisk system.  So, it must be something with this 
> particular motherboard or hardware configuration, but is there 
> anything I can do to solve the problem?
>
> Searches through the archives and Google do not show anything relevant 
> on this error message that I was able to find.
>
> Hardware Specs:
>  - Intel 440GX+ motherboard
>  - 500mhz PIII processor
>  - 1u case (horizontal PCI card - no, it's not shorting out)
>
Just a thought, could it not be somthing to do with the PCI riser card? 
is there anyway to plug the T100P directly into one of the PCI slots on 
the MB (maybe by taking the backing plate off).. this would at least 
eliminate the riser as the protential problem..

Later..