[Asterisk-Users] IAX2 connectivity problem (qualify=yes)

[WipeOut]

Philipp von Klitzing wrote:

>Hi there,
>
>I still have issues with the IAX connection between two servers (one 
>static (server A), one dynamic (server B), none behind NAT):
>
>B registers with A, and "iax2 show registry" shows that everything is 
>fine. However, after a while if I check on server A with "iax2 show 
>peers" I see a status of UKNOWN (in iax.conf there is a qualify=yes 
>statement for server B).
>
>The problem is that the connection to server B regularly gets worse than 
>2000 ms and is thus temporarily listed as unavailable - fine so far, that 
>is correct. But at some point server A stops to pick up the working (!) 
>connection and permanently shows status UNKOWN although the connection 
>is fine again (40 ms or so). It does help to issue a "reload" on server 
>A, but that's for sure not the way it should be... without that "reload" 
>server B will be permanently unavailable.
>
>Has anyone else seen this? Suggestions?
>
>Cheers, Philipp
>
>
>  
>
Try "qualify=3000" which will increase the time between checks.. 
Although it sounds like there is more to this problem than just 
increasing the time..

Later..