[Asterisk-Users] Some problems about X100P in Japan

[Shinsuke,Iwata]

Thanks for your good advice.

> You shouldn't need ZERO_BATT_RING unless you're using a line coming off
> of a TA, and if you are then you may not get disconnect supervision,
> depending on your TA.
> In any case, the disconnect supervision (AKA CPC) on PSTN lines in
> Japan is very very short.
> Look in wcfxo.c and play with the value of BATT_DEBOUNCE.  Try lowering
> it until you get hangup detection.
> You may also want to verify that you _are_ receiving the CPC signal.
> Either use an analog multimeter across the line or hold down the tone
> on a line-powered tone phone while the calling party hangs up and see
> if the tone or voltage goes away, even very briefly.

I had checked to detect supervision signal via TA, and verify recieved
signal is good, by multimeter.
And change the value of BATT_DEBOUNCE in wcfxo.c lowering.
But often X100P doesn't get hangup detection.(but often get hangup
detection)
So, I had changed config to decetet by busy tone, but not the disconnect
supervision.
And then, it works well, Now.
I will trying to use by this config, for several days.

thanks.

P.S.
->TokyoJimu
Are you staying in Japan?

-----------------------------
Shinsuke,Iwata
Japan
shinsuke at infoworks.ne.jp