Fwd: Re: [Asterisk-Users] Clarification (SIP Behind NAT question)

[John Todd]

I shouldn't have spoken so quickly.

I just tested an ATA-186 to verify what I had said in the negative, 
and I find that leaving the ConnectMode set to 0x00060400 (the 
default from the factory on v2.15) doesn't seem to make a difference 
- my ATA behind a NAT worked just fine.  Go figure.

JT


>You may have read the earlier posts on it, but to make sure: you did 
>set ConnectMode to 0x00460400 right?  Also, you have "nat=1" in the 
>settings for your ATA-186 in sip.conf?  Both are required for 
>correct functionality as far as I've seen.
>
>(Note: I've got an ATA-186 on a public IP address connected to * now 
>with ConnectMode set to 0x00460400 with seemingly no adverse issues. 
>Can anyone else verify?  This would be convenient for general 
>configuration for bulk roll-outs if both public and private 
>addressed ATA-186's can have the same settings.)
>
>JT
>
>
>At 4:17 PM -0600 3/11/03, Matthew Farley wrote:
>>
>>After sending my most recent message, I realized that I did not word it
>>clearly. In case of any confusion as to my configuration, my Asterisk
>>machine has a public IP, and the ATA186 is behind a NAT firewall. My
>>apologies for any confusion.
>>
>>--
>>Matthew Farley <asterisk at wheatstate.net>
>
>
>
>>On your Cisco ATA-186:
>>
>>Set your IP address information as usual (use DHCP, or static, 
>>whatever your site requires)
>>UID0: [your UID]
>>PWD0: [this UID's password]
>>UseSIP: 1
>>SIPRegInterval: 240
>>GkOrProxy: [ip address of your Asterisk server]
>>Gateway: [ip address of your Asterisk server]
>>ConnectMode: 0x00460400
>>OutBoundProxy: [ip address of your Asterisk server]
>