[Asterisk-Users] Re: Tormenta ISA E1 card

[Konrad Gorski]

crc ? Try:
span=1,0,0,ccs,hdb3,crc4

Konrad

-----Original Message-----
From: asterisk-users-admin at lists.digium.com
[mailto:asterisk-users-admin at lists.digium.com] On Behalf Of
info at itwav.com
Sent: Friday, March 07, 2003 3:03 AM
To: asterisk-users at lists.digium.com
Subject: [Asterisk-Users] Re: Tormenta ISA E1 card

If I comment all lines of zaptel.conf,after I run the ztcfg,the warning
in 
the zttool is OK, that is to say,no warning.

If I leave the zaptel.conf's content as:
span=1,0,0,ccs,hdb3
span=2,0,0,ccs,hdb3 

then the RED warning will appear. 

I I connect a "loop back" line into span1's RJ45 socket,then the warning

become RED/YELLOW. 


if I config the span1 as PRI_NET and span2 as PRI_CPE and connect them
with 
a cable ,after I run the asterisk with -vvvvc,I could see the Tor
channels 
are started. But when I dial the extenion based on zaptel's channel,I
always 
got the information that the channel is busy. 

(if I change the chip and crystal to T1's,then all is OK!) 

Regards 

                     john 


Steve Underwood writes: 

> info at itwav.com wrote: 
> 
>> Hi,Steve,
>> My ISA E1 card does not work yet. I would like to know if there are
>> other difference bettween then two kind of ISA card?
> 
> The crystals, the framer chips and the jumpers are the only
differences.
> What are the symptons of it not working? 
> 
> Regards,
> Steve 
> 
>  
> 
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
 
_______________________________________________
Asterisk-Users mailing list
Asterisk-Users at lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users